single rack cylinder Sold to Bangladesh

This article mainly introduces:

Bangladesh hydraulic cylinder,single rack cylinder manufacturer,single rack cylinder

(Bangladesh single rack cylinder,produced by Hengyu Group）

single rack cylinder are widely used in Bangladesh，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed single rack cylinder for customers from Bangladesh.

Introduction to single rack cylinder:

If the piston rod and single rack cylinder are stuck or the single rack cylinder is blocked, at this time, no matter how to operate, the single rack cylinder does not move or has little action. At this time, check whether the piston and piston rod seal is too tight, whether it enters the dirt and gum deposits: whether the shaft line of the piston rod and the single rack cylinder is in the center, whether the wearing parts and seals are invalid, and whether the load is too large.

single rack cylinder daily maintenance, should focus on checking whether the piston rod surface roughness and shape and position tolerance meet the technical requirements, if the piston rod bending should be calibrated to meet the requirements or according to the physical mapping, manufactured by a professional manufacturer. If the piston rod surface coating wear, slip damage, local spalling can be adopted to remove the coating, re-chrome surface processing process.

At the rated pressure, the thrust of the single rack cylinder is determined by what factors: at the rated pressure of the oil pump, the work done by the single rack cylinder is related to the diameter of the single rack cylinder, but not to the stroke of the single rack cylinder. Moreover, the larger the single rack cylinder diameter, the larger the area, and the greater the pressure obtained. To this point, we should have a correct understanding and clear understanding, so as to avoid problems in the use of the single rack cylinder.

single rack cylinder piston rod material introduction: In general, we use 45 steel to produce single rack cylinder piston rod. It has a large impact force when it is used, and some good performance steel are also used in the heavy load transmission. In order to have enough work intensity when using, and can ensure normal use, this is still more critical to have a detailed understanding of the material.

Answers to some questions about single rack cylinder:

Hydraulic system schematic diagram, pipeline identification S and L, respectively corresponding nominal diameters? 16S is equivalent to DN12 high-pressure cylinder, and 15L means what?
16S refers to the high pressure series, outer diameter 16x2 steel pipe, the corresponding sleeve nut is M24X1.515L is the low pressure series, the outer diameter of 15x1.5 steel pipe, the corresponding sleeve nut is M22X1.5.

What diameter cylinder is needed for a force of 5 tons?
It depends on the pressure of your system pump. If the normal working pressure of the system is about 8MPa, then the diameter of the cylinder should be 100 mm.