sanitation truck hydraulic cylinder Sold to Singapore

This article mainly introduces:

Singapore hydraulic cylinder,sanitation truck hydraulic cylinder manufacturer,sanitation truck hydraulic cylinder

(Singapore sanitation truck hydraulic cylinder,produced by Hebei Hengyu company）

sanitation truck hydraulic cylinder are widely used in Singapore，because of no need for deceleration device，high work efficiency，excellent fatigue and impact resistance.So our company has designed sanitation truck hydraulic cylinder for customers from Singapore.

Introduction to sanitation truck hydraulic cylinder:

The internal leakage of the sanitation truck hydraulic cylinder should be prevented when the sanitation truck hydraulic cylinder is used. The internal leakage of sanitation truck hydraulic cylinder includes the leakage caused by excessive wear of sanitation truck hydraulic cylinder block seal, piston rod and seal cover seal and piston seal. The cause of sealing leakage between the piston rod and the seal cover is that the seal is wrinkled, squeezed, torn, worn, aging, deterioration, deformation, etc., and a new seal should be replaced at this time.

The viscosity of the working oil used in the sanitation truck hydraulic cylinder is 29~74mm2/S, and ISO VG46 anti-wear hydraulic oil is recommended. Working oil temperature within the range of -20~80. C. When the ambient temperature and service temperature are low, the oil with lower viscosity can be selected.

sanitation truck hydraulic cylinder seal leakage causes and countermeasures: a. Loose tie rod nut will cause leakage, tighten the tie rod nut according to the torque requirements of tie rod nut, test no leakage can continue to use. b. Pressure exceeding the limit will also cause leakage. Replace the sanitation truck hydraulic cylinder seal and re-tighten the tie rod nut to reduce the pressure to the nominal pressure range of the sanitation truck hydraulic cylinder. c. The sanitation truck hydraulic cylinder seal is extruded, if the O-ring is obviously extruded at the sanitation truck hydraulic cylinder seal, replace the sanitation truck hydraulic cylinder seal.

The main role of the sanitation truck hydraulic cylinder: the sanitation truck hydraulic cylinder is an executive element in the hydraulic transmission system, which is an energy conversion device that converts hydraulic energy into mechanical energy. The hydraulic motor realizes continuous rotary motion, while the sanitation truck hydraulic cylinder realizes reciprocating motion. The structure of the sanitation truck hydraulic cylinder has three categories: piston sanitation truck hydraulic cylinder, plunger sanitation truck hydraulic cylinder, swing sanitation truck hydraulic cylinder, piston sanitation truck hydraulic cylinder and plunger sanitation truck hydraulic cylinder to achieve reciprocating linear motion, output speed and thrust, swing sanitation truck hydraulic cylinder to achieve reciprocating swing, output angular speed (speed) and torque. In addition to the single use of the sanitation truck hydraulic cylinder, two or more can be combined or used in combination with other mechanisms. To fulfill a special function. The sanitation truck hydraulic cylinder has simple structure and reliable operation, and has been widely used in the hydraulic system of machine tools.

Answers to some questions about sanitation truck hydraulic cylinder:

What is the meaning of cylinder HSGK01-100/70E-4111-1320?
hsg Double acting single piston rod hydraulic cylinder and front end cover are connected by internal clamp key 01 Design serial number 100 cylinder inner diameter 70 piston rod outer diameter e Pressure class code 16mpa4111 Front flange, rod end external thread, both ends with buffer, oil port connection is internal thread 1320 stroke.

What are the standard cylinder models for hydraulic cylinders?
National standard GB/T2348-1993 specifies the hydraulic cylinder inner diameter series, you can check GB/T2348-1993 relevant regulations.