track steering cylinder Sold to Brazil

This article mainly introduces:

Brazil hydraulic cylinder,track steering cylinder manufacturer,track steering cylinder

(Brazil track steering cylinder,produced by Hengyu Hydraulic Co., Ltd）

track steering cylinder are widely used in Brazil，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed track steering cylinder for customers from Brazil.

Introduction to track steering cylinder:

When installing the track steering cylinder, the axial ends of the track steering cylinder cannot be fixed. Due to the effect of liquid pressure and thermal expansion in the track steering cylinder, there is axial expansion. If the two ends of the track steering cylinder are fixed, all parts of the track steering cylinder will be deformed. When disassembling the track steering cylinder, it is strictly forbidden to hammer the track steering cylinder and the piston surface, such as the track steering cylinder hole and the piston surface is damaged, do not allow sandpaper grinding, to use a fine oil stone carefully grinding. The clearance between the guide sleeve and the piston rod should meet the requirements.

Do not enter foreign bodies when installing the track steering cylinder block. The place where the installation operation is carried out, the conditions are not good, and foreign bodies can be entered unconsciously. Therefore, the installation site must be cleaned up around, especially the place where the parts are placed must be cleaned, so that there is no dirt.

In the hydraulic system, sometimes the inner layer of the rubber hose is peeled off, so that the oil circuit is on and off, resulting in irregular track steering cylinder action. Troubleshooting method: Replace the rubber hose.

When the control pressure of the hydraulic system is too low, the track steering cylinder will appear wrong or no action, because the throttle resistance in the control pipeline may be too large, the flow valve is improperly adjusted, the control pressure is inappropriate, and the pressure source is interfered with. At this time, check the control pressure source to ensure that the pressure is adjusted to the specified value of the system.

Answers to some questions about track steering cylinder:

The two cylinders of the bending machine are out of sync?
Check whether the sliding slide is worn, adjust its tightness, so that both sides are consistent, check whether the two cylinder tubing is connected, tighten the flow valve, pressure, let the cylinder air discharge.

Why hydraulic cylinder load can not rise?
The hydraulic cylinder does not top up indicates that the pressure of the working chamber of the hydraulic cylinder is insufficient, and the following circumstances can lead to insufficient pressure: 1) The relief valve of the hydraulic system cannot establish pressure, elimination method: check whether the pressure setting screw of the relief valve is screwed to the appropriate position. If it is an electromagnetic relief valve, please check the power-on condition. 2) The hydraulic system pipeline is connected incorrectly, when P and T are connected, this must be checked and excluded; 3) Excessive leakage in the hydraulic cylinder, resulting in (only for double-acting cylinders); 3) No hydraulic oil into the working chamber of the hydraulic cylinder, elimination method: first disassemble the hydraulic pipe connecting the reversing valve and the hydraulic cylinder, and then control the reversing valve, and observe whether there is hydraulic oil flowing out of the reversing valve.