steering cylinder Sold to Sudan

This article mainly introduces:

Sudan hydraulic cylinder,steering cylinder manufacturer,steering cylinder

(Sudan steering cylinder,produced by Hengyu Hydraulic Co., Ltd）

steering cylinder are widely used in Sudan，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed steering cylinder for customers from Sudan.

Introduction to steering cylinder:

If air enters the hydraulic system, the steering cylinder will not operate normally, mainly because there is a leak in the system. At this time, check the liquid level of the hydraulic tank, the seals and fittings on the oil suction side of the hydraulic pump, and whether the oil suction filter is too dirty. If so, the hydraulic oil should be replenished, seals and fittings should be treated, and the coarse filter element should be cleaned or replaced.

The body of the steering cylinder on the processing process requirements: the body of the steering cylinder is an important and essential part of the steering cylinder, because it has an irreplaceable role. The processing requirements for this part are very high, requiring that the surface roughness of the steering cylinder after processing should reach 0.4-0.8um, and the coaxiality and wear resistance requirements are also very high.

If the seal of the steering cylinder is softened and sticky, it may be that the seal is incompatible with the hydraulic oil or the nearby lubricating oil, replace the appropriate seal; If the seal becomes hard and loses elasticity, most of it is because the ambient temperature is too high (more than 80 ° C), make appropriate temperature insulation protection or replace the high temperature seal.

If it is found that the steering cylinder lubrication is poor or the steering cylinder bore processing is abnormal, it is necessary to feedback the situation to the manufacturer, because the piston and the steering cylinder, the guide rail and the piston rod have relative movement, if the lubrication is poor or the steering cylinder bore is abnormal, it will aggravate the wear and reduce the straightness of the steering cylinder center line. In this way, when the piston works in the steering cylinder, the friction resistance will be large and small, resulting in slip or crawling. The solution is to repair and grind the steering cylinder first, and then prepare the piston according to the matching requirements, repair and grind the piston rod, and configure the guide sleeve.

Answers to some questions about steering cylinder:

What is the relationship between medium cylinder and side cylinder ratio of forklift truck?
The middle cylinder and the side cylinder seem to have no relationship, as long as the lifting speed required by the design can be ensured, but the diameter of the cylinder can not be too thin, so as to avoid the middle cylinder acting first when the high gantry vibration lifting, and then the two cylinders acting again.

How many tons is the oil cylinder 16mpa?
It depends on the cross-sectional area of the cylinder A(mm2)F=16mpa×A unit is (tons).