pressure retaining cylinder Sold to Poland

This article mainly introduces:

Poland hydraulic cylinder,pressure retaining cylinder manufacturer,pressure retaining cylinder

(Poland pressure retaining cylinder,produced by Hengyu Group）

pressure retaining cylinder are widely used in Poland，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed pressure retaining cylinder for customers from Poland.

Introduction to pressure retaining cylinder:

1, the hydraulic machinery should be kept clean, in order to prevent dust and debris from falling into the oil, the tank should be sealed. 2, the oil in the tank should be replaced regularly according to the working condition. When changing the oil, the dirt and impurities accumulated at the bottom of the tank should be removed and the tank should be cleaned. 3, hydraulic oil, oil drums should be set in a clean and safe place to strengthen management. The oil drum, oil filter, oil funnel, oil pipe, etc. used should be kept clean. The oil drums for loading hydraulic oil must be cleaned in advance, and the oil drums should be dedicated and not mixed with other oil drums.

Repair method of small range wear of oil pressure retaining cylinder: 1. Use oxygen-acetylene flame to bake the scratched part (master the temperature, avoid surface annealing), bake the oil on the metal surface all the year round until no sparks splash; 2. The scratched part is treated with an Angle grinder, the grinding depth is more than 1 mm, and the groove is polished along the guide rail, preferably a dovetail groove. Scratch both ends of the drilling deeper, change the force situation; 3. Clean the surface with absorbent cotton dipped in acetone or anhydrous ethanol.

pressure retaining cylinder and hydraulic station selection: Select the type and structure of the pressure retaining cylinder according to the operation requirements of the main engine. According to the external load force borne by the pressure retaining cylinder, such as gravity, friction force of the external mechanism, inertia force and working load, determine the load change law of the pressure retaining cylinder in each stage of the stroke and the power value that must be provided. Determine the diameter of the piston and piston rod according to the working load of the pressure retaining cylinder and the selected oil working pressure. the flow rate of the hydraulic pump is determined according to the movement speed of the pressure retaining cylinder, the diameter of the piston and the piston rod.

In the case of serious wear on the inner surface of the pressure retaining cylinder, or when there is a deep longitudinal tensile mark, it should be mapped according to the physical object and re-produced by the professional manufacturer according to the pressure retaining cylinder manufacturing process for replacement. The pressure retaining cylinder can also be repaired with TS311 antiwear repair agent. TS311 anti-wear repair agent is mainly used for the repair of worn and slipped metal parts.

Answers to some questions about pressure retaining cylinder:

What is the reason for the hydraulic cylinder sticking out and not retracting?
There are two reasons: First, the problem with the seal, if there are two seals on the piston, the top seal is broken. Second, when the hydraulic pressure itself is designed, the rod cavity area is too small, so that the desired return force can not be achieved during the return trip. You can first check whether the coupling is damaged; Then see if the relief valve in the oil line block is blocked. If the use time is too long, it needs to be cleaned, the hydraulic oil is very dirty and can block oil block. Electromagnetic directional valves can also be checked, but the chance of problems is relatively small, unless there is a product problem.

Why should the piston rod of the hydraulic cylinder be so precise? If you hope the cylinder has a long service cycle, then all parts need to be high-precision, not only the piston rod, but also the cylinder, the sealing groove, the surface roughness, the cylinder looks very simple. Any hydraulic factory can produce the cylinder, but the good cylinder is difficult to produce.