trailer hydraulic cylinder Sold to Switzerland

This article mainly introduces:

Switzerland hydraulic cylinder,trailer hydraulic cylinder manufacturer,trailer hydraulic cylinder

(Switzerland trailer hydraulic cylinder,produced by Hengyu Group）

trailer hydraulic cylinder are widely used in Switzerland，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed trailer hydraulic cylinder for customers from Switzerland.

Introduction to trailer hydraulic cylinder:

The coordination of the sliding parts of the trailer hydraulic cylinder itself should not be too tight, the sealing friction force should not be too large, and H8 / f8 coordination should be selected between the piston rod and the guide sleeve; Check whether the size of the sealing ring is processed strictly according to the standard; If the V-shaped sealing ring is used, the sealing friction should be adjusted to a moderate degree.

Under normal circumstances, the trailer hydraulic cylinder is composed of the rear end cover, body, piston, piston rod and front end cover and other main parts. In order to prevent the working medium from leaking out of the trailer hydraulic cylinder or from the high pressure chamber to the low pressure chamber, a sealing device (sealing ring) is arranged between the trailer hydraulic cylinder and the end cover, the piston and the piston rod, the piston and the trailer hydraulic cylinder, the piston rod and the front end cover. A dustproof device is also provided on the outside of the front end cover. In order to prevent the piston from impacting the end cap when it moves rapidly to the end of the stroke, the end of the trailer hydraulic cylinder can also be provided with a buffer device. If necessary, the exhaust device should be set in order to exhaust.

The difference between the plunger trailer hydraulic cylinder and the piston trailer hydraulic cylinder is that the piston in the trailer hydraulic cylinder is replaced by a shaft plunger, which is used in hydraulic transmission requiring a long mechanical stroke, and can only input pressure oil from one direction, pressurize in a single direction, and form a thrust to push the plunger to move. The return trip of the plunger depends on the plunger itself to fall, and some rely on the spring to push back to the original position. Usually used plunger type trailer hydraulic cylinder, its inner hole does not need mechanical finishing, as long as the plunger round grinding can be assembled.

trailer hydraulic cylinder buffer valve inspection and maintenance: For the valve buffer trailer hydraulic cylinder, the focus should be on checking the wear of the buffer valve spool and seat. Once it is found that the amount of wear increases and the seal fails, it should be replaced. It can also be repaired by using abrasive spool and seat matching grinding method.

Answers to some questions about trailer hydraulic cylinder:

How to select the 2.5T bearing cylinder and hydraulic pump?
2,5 ton load is not heavy, you can use the rated pressure of 16 mpa gear pump, neither waste nor save cost, load/pressure = cylinder diameter, preset pressure of 8 mpa, 2500 (kg) /80 (bar) =31.25 square centimeters, in the open =63 mm, cylinder diameter can be selected 63 mm, stroke according to the situation, Hydraulic pump select gear pump, if there is a speed requirement, in order to calculate the displacement, the motor power also needs to determine the displacement of the pump to calculate.

How long can a hydraulic cylinder work continuously?
If the maintenance is good, the service life can be extended a lot. The life of the cylinder is related to the structure of the cylinder, working pressure, stress state, hydraulic oil cleanliness, oil temperature control, maintenance and preventive measures. For example, the cylinder structure, the inner wall of the cylinder has quilting, rolling, chrome plating and other methods, the sealing parts have polyurethane rings, glay rings, metal sealing rings, etc., different combinations, the life difference is dozens of times. Metallurgical system is a typical cylinder application, in 24 hours of work, a year or more can not be shut down, in the middle of continuous work.