300 tons hydrauli ccylinder Sold to Guatemala

This article mainly introduces:

Guatemala hydraulic cylinder,300 tons hydrauli ccylinder manufacturer,300 tons hydrauli ccylinder

(Guatemala 300 tons hydrauli ccylinder,produced by Hengyu Hydraulic Co., Ltd）

300 tons hydrauli ccylinder are widely used in Guatemala，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed 300 tons hydrauli ccylinder for customers from Guatemala.

Introduction to 300 tons hydrauli ccylinder:

In use, the 300 tons hydrauli ccylinder should try to avoid the friction iron powder or iron filings formed by buffering the plunger. When the matching gap of the buffer device is small and the transverse load on the piston rod is large, the sintering phenomenon may be caused. These friction iron powder or the metal fragments that have fallen off as a result of sintering will remain in the 300 tons hydrauli ccylinder.

Protection of the 300 tons hydrauli ccylinder surface: During the dismantling process, safety protection should be carried out on the 300 tons hydrauli ccylinder to prevent objects from falling and welding slag from falling to the surface, causing damage to the 300 tons hydrauli ccylinder surface. In the process of propulsion, the damaged pipe segments should be prevented from falling and smashing, and the slurry remaining on the surface of the 300 tons hydrauli ccylinder should be cleaned up in time.

The 300 tons hydrauli ccylinder should be vented: when the 300 tons hydrauli ccylinder is installed or parked for a long time to work again, the air will penetrate into the 300 tons hydrauli ccylinder and the pipeline system. In order to prevent the abnormal phenomenon of crawling, noise and heating of the actuator, the air in the 300 tons hydrauli ccylinder and the system should be discharged. In order to facilitate the removal of air deposited in the 300 tons hydrauli ccylinder, the oil is best entered and discharged from the highest point of the 300 tons hydrauli ccylinder. 300 tons hydrauli ccylinders that require higher motion stability are often equipped with exhaust plugs at both ends. Before working, unscrew the exhaust plug to make the piston go back and forth several times without load in the whole stroke, and the air can be discharged through the exhaust plug. After the air is drained, tighten the exhaust plug before working.

Do not regularly check the damage of the chrome layer of the 300 tons hydrauli ccylinder: completely extend the 300 tons hydrauli ccylinder and carefully check whether there is any surface damage such as injury, strain, welding slag, such as the surface damage position, in the 300 tons hydrauli ccylinder block < 20cm, and the damage depth < 5mm, should be repaired in time to prevent long-term damage to the 300 tons hydrauli ccylinder seal. Welding slag is strictly prohibited on the surface of the 300 tons hydrauli ccylinder.

Answers to some questions about 300 tons hydrauli ccylinder:

How to repair the bent oil cylinder correctly?
If the bending oil cylinder leaks, the most direct way is to replace the seal ring. Most of the sealing rings used by domestic bending machines are made in Taiwan and Japan, so the service life of the sealing ring is still relatively long. If the bending oil cylinder used by the customer leaks oil, then when replacing the seal ring, be sure to choose a high-quality and durable seal ring. In this way, the replaced cylinder will not leak oil for a long time.

How to distinguish loader boom and forearm hydraulic cylinder? Is it the upper arm or the lower arm?
The one in the middle that can flip the bucket is the small arm cylinder you say, and the one that lifts the brackets (big arms) on both sides is the big arm cylinder.