trailer hydraulic cylinder Sold to Ireland

This article mainly introduces:

Ireland hydraulic cylinder,trailer hydraulic cylinder manufacturer,trailer hydraulic cylinder

(Ireland trailer hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

trailer hydraulic cylinder are widely used in Ireland，because of long service life，smooth movement，high work efficiency.So our company has designed trailer hydraulic cylinder for customers from Ireland.

Introduction to trailer hydraulic cylinder:

The repair method of trailer hydraulic cylinder wear: 1. Metal repair material is applied to the scratched surface; The first layer should be thin, uniform and fully covered with the scratched surface to ensure the best adhesion between the material and the metal surface, and then apply the material to the entire repair site and press repeatedly to ensure that the material is filled and reaches the required thickness, so that it is slightly higher than the surface of the guide rail; 2, the material at 24℃ to fully achieve the performance of 24 hours, in order to save time, can be through the tungsten halogen lamp to increase the temperature, the temperature rises 11℃, the curing time will be reduced by half, the best curing temperature 70℃; 3. After the material is cured, use a fine grinding stone or a scraper to repair and smooth the material higher than the surface of the guide rail, and the construction is completed.

trailer hydraulic cylinder can not drive the load troubleshooting: oil pressure is too low. trailer hydraulic cylinder selection specifications are too small. Leakage in trailer hydraulic cylinder or associated hydraulic system element.

Most of the failure of the trailer hydraulic cylinder is because there is a foreign body in the trailer hydraulic cylinder into the failure of the trailer hydraulic cylinder, the most problematic is that it is difficult to determine when the foreign body is into the trailer hydraulic cylinder. After a foreign body enters, if the outer side of the sliding surface of the piston is equipped with a seal with a lip edge, then the lip edge of the seal can scrape the foreign body when working, which is beneficial to avoid scratching. However, the piston equipped with 0-shaped sealing ring has a sliding surface at both ends, and foreign bodies are sandwiched between this sliding surface, which is easy to form scars.

How the cavitation of the trailer hydraulic cylinder is formed: With the gradual rise of pressure, the gas in the oil will become bubbles, when the pressure rises to a certain limit value, these bubbles will break under the action of high pressure, so that the high temperature and high pressure gas will quickly act on the surface of the parts, resulting in cavitation of the trailer hydraulic cylinder, resulting in corrosive damage to the parts.

Answers to some questions about trailer hydraulic cylinder:

What are the four cylinders of the truck crane?
The four cylinders of the truck crane generally refer to the telescopic cylinder of the boom (to adjust the length of the boom), the variable amplitude cylinder of the boom (to adjust the elevation Angle of the boom), the horizontal telescopic cylinder of the support leg and the vertical cylinder of the support leg.

What material should be selected to seal the cylinder?
The choice of material for sealing is related to the working environment, strength, and medium of your equipment.