steel mill cylinder Sold to Kazakhstan

This article mainly introduces:

Kazakhstan hydraulic cylinder,steel mill cylinder manufacturer,steel mill cylinder

(Kazakhstan steel mill cylinder,produced by Hengyu Hydraulic Co., Ltd）

steel mill cylinder are widely used in Kazakhstan，because of high work efficiency，long service life，smooth movement.So our company has designed steel mill cylinder for customers from Kazakhstan.

Introduction to steel mill cylinder:

steel mill cylinder can not drive the load troubleshooting: oil pressure is too low. steel mill cylinder selection specifications are too small. Leakage in steel mill cylinder or associated hydraulic system element.

The pressure of the sliding surface of the steel mill cylinder piston is too large, resulting in sintering. The piston tilts due to the weight of the piston rod, resulting in the phenomenon of non-stiffness, or the pressure of the sliding surface of the piston rises due to the action of the transverse load, which will cause sintering. In the design of the steel mill cylinder must study its working conditions, the length of the piston and bushing and the size of the clearance must be fully paid attention to.

When the steel mill cylinder needs to be disassembled for maintenance due to leakage and other faults, the piston should be moved to the bottom position of the steel mill cylinder, and hard beating and sudden drop are strictly prohibited during disassembly.

The internal leakage of the steel mill cylinder should be prevented when the steel mill cylinder is used. The internal leakage of steel mill cylinder includes the leakage caused by excessive wear of steel mill cylinder block seal, piston rod and seal cover seal and piston seal. The cause of sealing leakage between the piston rod and the seal cover is that the seal is wrinkled, squeezed, torn, worn, aging, deterioration, deformation, etc., and a new seal should be replaced at this time.

Answers to some questions about steel mill cylinder:

How to select swing cylinder? Under what conditions are they designed and selected?
1, determine the system parameters: ① the weight and the required force; ② Nominal working pressure and range; ③ The time required to travel this distance; 4 oil medium 2, installation method: select the appropriate way for the specific application 3, cylinder diameter and working pressure: determine the cylinder diameter and provide the necessary force required by the system pressure 4, piston rod: determine the minimum piston rod diameter required to withstand the longitudinal bending force, select the appropriate piston rod end and piston rod end thread 5, piston: Whether the seal type is suitable for the application 6, buffer: choose the buffer requirements as appropriate.

Why do two hydraulic cylinders lift out of sync?
There may be several situations (do not know the result of the equipment, may not be accurate) 1, whether the slow one is worn 2, whether there is air in the slow cylinder 3, if the two cylinders are supplied by the same oil port, whether the slow joint is blocked (some processing residue will reach a certain oil port under a certain coincidence condition, This situation will not happen if it is not necessarily good before) 4, the oil seal in the slow cylinder leaks, causing the feed oil to leak from the return oil end. Point 4 is most likely because it is invisible and a technical failure. If it is a dual oil feed (separate oil feed), it is also necessary to check the oil supply system and the oil return system (valve type).