flange type cylinder Sold to Switzerland

This article mainly introduces:

Switzerland hydraulic cylinder,flange type cylinder manufacturer,flange type cylinder

(Switzerland flange type cylinder,produced by Hengyu Group）

flange type cylinder are widely used in Switzerland，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed flange type cylinder for customers from Switzerland.

Introduction to flange type cylinder:

If the flange type cylinder slips or crawls, please check whether there is astringency inside the flange type cylinder, because the internal parts of the flange type cylinder are improperly assembled, the parts are deformed, worn or the shape and position tolerance is excessive, the action resistance is too large, so that the piston speed of the flange type cylinder changes with the different stroke position, and the slip or crawl occurs. Most of the reasons are due to poor assembly quality of parts, surface scars or sintered iron filings, so that the resistance increases, the speed decreases. For example, the piston is different from the piston rod or the piston rod is bent, the flange type cylinder or the piston rod is offset from the mounting position of the guide rail, and the sealing ring is too tight or too loose. The solution is to repair or adjust, replace damaged parts and remove iron filings.

The difference between the integral flange type cylinder and the split flange type cylinder: The integral flange type cylinder and the split flange type cylinder in the flange type cylinder are two different flange type cylinders, and they are very different. The whole flange type cylinder, which is cast in one body, is not prone to problems such as oil leakage; The split flange type cylinder is welded twice, so if it is not handled well at the welding, it is prone to problems such as oil leakage and flange type cylinder damage. Therefore, it is obvious that the answer to this question is for difference.

flange type cylinder can not drive the load troubleshooting: oil pressure is too low. flange type cylinder selection specifications are too small. Leakage in flange type cylinder or associated hydraulic system element.

The scar on the sliding surface of the flange type cylinder piston will transfer with use. Before the piston is installed, there are scars on its sliding surface, which are installed intact and untreated, and these scars will in turn scratch the inner surface of the flange type cylinder wall. Therefore, before installation, these scars must be fully repaired.

Answers to some questions about flange type cylinder:

CNC lathe rotary cylinder oil leakage and treatment methods
Oil leakage often occurs when the cylinder (especially the hollow cylinder) of the CNC lathe is installed. First check the cylinder yaw, be sure to reach or close to the required value, generally the cylinder requires the outer beat within 1 wire. Otherwise, too much beating is sure to leak oil. Then check whether the tubing is smoothly downward at a certain Angle, and can not bend. Look at the pipe outlet can not go into the oil level, to a little higher. Otherwise, there's back pressure and it's gonna leak.

How big is the 100t cylinder pump and how big is the motor?
Load is calculated at 15 tons, stroke is calculated at 100 (both take the maximum) 15 tons = 15,000 kg, 15,000/210 bar (21 mpa) =71.42 square centimeters (cylinder area) 71.42/3,14 In the root *2=90,5 the inner diameter of the cylinder can be taken 100 mm. Travel 100 cm, that is, one meter, assuming 10, seconds a back and forth, then it is six times a minute, six meters per minute, then the required flow is,71,42*600 cm (6 meters) =42840 mm =42.84 liters/minute 42.84*21/60=14.9 kilowatts can choose 1450 RPM 4-stage motor 15KW.