swager cylinder Sold to Luxembourg

This article mainly introduces:

Luxembourg hydraulic cylinder,swager cylinder manufacturer,swager cylinder

(Luxembourg swager cylinder,produced by Hengyu Group）

swager cylinder are widely used in Luxembourg，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed swager cylinder for customers from Luxembourg.

Introduction to swager cylinder:

The "O" ring can be used as an auxiliary seal inside the swager cylinder, and the elastic force of the "O" ring makes the sealing slip ring close to the sealing surface, generating sealing pressure to achieve sealing. When the internal hydraulic pressure increases, the "O" ring will further deform and squeeze the slip ring, thereby increasing the sealing pressure and improving the sealing performance. The structure has the characteristics of low friction coefficient, good wear resistance, automatic compensation for wear and absorption of hard particles in the swager cylinder, and can be completely sealed.

The viscosity of the working oil used in the swager cylinder is 29~74mm2/S, and ISO VG46 anti-wear hydraulic oil is recommended. Working oil temperature within the range of -20~80. C. When the ambient temperature and service temperature are low, the oil with lower viscosity can be selected.

Causes and countermeasures of oil swager cylinder leakage: Cast iron ring seal allows a certain degree of internal leakage. The impurities in the swager cylinder will lead to premature wear of the piston seal, replace the piston seal; If the swager cylinder is visibly scarred, the swager cylinder must be replaced. It can be pressurized at one end of the swager cylinder and opened at the other end of the oil port to observe whether there is obvious internal leakage at the end of the oil port. Most swager cylinder piston drift may not come from the swager cylinder, the above method to determine the swager cylinder without internal leakage is helpful to determine the problem of the hydraulic system related components.

swager cylinder hydraulic oil selection: The recommended working oil viscosity of the swager cylinder is 10 ~ 110cSt (1.8 ~ 15E), ISO VG46 hydraulic oil. The normal working oil temperature is 10 ~ 70℃, and the ambient temperature is in the range of -20 ~ 80℃. When the ambient temperature and service temperature are low, the hydraulic oil with lower viscosity can be selected.

Answers to some questions about swager cylinder:

What steel pipe does hydraulic cylinder use? This problem is very general. Carbon steel pipe or ordinary seamless steel pipe are all ok, but then there are rolling, quilting, heat treatment and other steps, and the requirements are different, the wall thickness is different, the material is different. It depends on the circumstances.

Hydraulic cylinder performance requirements?
Hydraulic cylinder performance requirements: hydraulic cylinder is the hydraulic system to achieve energy transfer, conversion and control of the working medium, in addition, it is also responsible for the lubrication of the system, rust prevention, corrosion prevention and cooling. The performance of hydraulic oil will make the system flexible, accurate and reliable. Hydraulic performance requirements are determined according to the design parameters of the hydraulic system, operating conditions, the structure of the hydraulic pump and the working environment. Appropriate viscosity and good viscosion-temperature performance Viscosity is an important performance indicator of hydraulic pressure, which has an important impact on the smooth operation of the hydraulic system and the friction parts. The low temperature performance of hydraulic oil includes three aspects: low temperature flow, low temperature start-up and low temperature pumping.