magnetic ring induction cylinder Sold to Japan

This article mainly introduces:

Japan hydraulic cylinder,magnetic ring induction cylinder manufacturer,magnetic ring induction cylinder

(Japan magnetic ring induction cylinder,produced by Hebei Hengyu company）

magnetic ring induction cylinder are widely used in Japan，because of long service life，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed magnetic ring induction cylinder for customers from Japan.

Introduction to magnetic ring induction cylinder:

1, the hydraulic machinery should be kept clean, in order to prevent dust and debris from falling into the oil, the tank should be sealed. 2, the oil in the tank should be replaced regularly according to the working condition. When changing the oil, the dirt and impurities accumulated at the bottom of the tank should be removed and the tank should be cleaned. 3, hydraulic oil, oil drums should be set in a clean and safe place to strengthen management. The oil drum, oil filter, oil funnel, oil pipe, etc. used should be kept clean. The oil drums for loading hydraulic oil must be cleaned in advance, and the oil drums should be dedicated and not mixed with other oil drums.

Before purchasing the magnetic ring induction cylinder, it is necessary to master the original information and design basis, mainly including: the use and working conditions of the machine; The structural characteristics, load conditions, stroke size and operation requirements of the working mechanism; The selected working pressure and flow of the hydraulic system; The reality of materials, fittings and processes; Relevant national standards and technical specifications, etc.

The "O" ring can be used as an auxiliary seal inside the magnetic ring induction cylinder, and the elastic force of the "O" ring makes the sealing slip ring close to the sealing surface, generating sealing pressure to achieve sealing. When the internal hydraulic pressure increases, the "O" ring will further deform and squeeze the slip ring, thereby increasing the sealing pressure and improving the sealing performance. The structure has the characteristics of low friction coefficient, good wear resistance, automatic compensation for wear and absorption of hard particles in the magnetic ring induction cylinder, and can be completely sealed.

Regular maintenance of the magnetic ring induction cylinder includes: regular tightening, magnetic ring induction cylinder fastening screws and gland screws, magnetic ring induction cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the magnetic ring induction cylinder once a year. Clean regularly, the magnetic ring induction cylinder is cleaned every other year, and the seals are replaced while cleaning.

Answers to some questions about magnetic ring induction cylinder:

What hydraulic valve is used to control a cylinder back and forth?
Direction valve is available. Direction valve includes electromagnetic directional valve, manual directional valve, check valve, hydraulic control check valve, the specific choice of which direction valve, you need to see the use of conditions.

How to design the guide sleeve of cylinder diameter 400?
The purpose of the guide sleeve is to guide and seal. Therefore, it is necessary to look at the speed of the piston rod, working pressure and radial force. High speed, medium pressure, no (or very little) radial force, with a Steseal. Low speed and heavy load, medium radial force, combined seal. High speed and heavy load, large radial force, sealed with DU sleeve + copper ring + combination. The combination seal must have a lubricating oil passage, and a seal must be added to the outside of the oil passage.