stroke adjustable cylinder Sold to Cameroon

This article mainly introduces:

Cameroon hydraulic cylinder,stroke adjustable cylinder manufacturer,stroke adjustable cylinder

(Cameroon stroke adjustable cylinder,produced by Hengyu Hydraulic Co., Ltd）

stroke adjustable cylinder are widely used in Cameroon，because of simple structure and reliable operation，simple structure and reliable operation，excellent temperature resistance.So our company has designed stroke adjustable cylinder for customers from Cameroon.

Introduction to stroke adjustable cylinder:

Protection of the stroke adjustable cylinder surface: During the dismantling process, safety protection should be carried out on the stroke adjustable cylinder to prevent objects from falling and welding slag from falling to the surface, causing damage to the stroke adjustable cylinder surface. In the process of propulsion, the damaged pipe segments should be prevented from falling and smashing, and the slurry remaining on the surface of the stroke adjustable cylinder should be cleaned up in time.

Before the stroke adjustable cylinder is removed, the system should be unloaded, the loop pressure is zero, the oil source should be cut off, and the oil port should be blocked after the oil port distribution pipe is loosened.

The stroke adjustable cylinder body is commonly made of No. 20, 35, 45 seamless steel pipe, and the steel pipe is honed or rolled to achieve the roughness requirement within 0.4μm. The low pressure stroke adjustable cylinder can use 20 steel pipe, and the high pressure stroke adjustable cylinder can use 45 steel pipe.

The difference between the plunger stroke adjustable cylinder and the piston stroke adjustable cylinder is that the piston in the stroke adjustable cylinder is replaced by a shaft plunger, which is used in hydraulic transmission requiring a long mechanical stroke, and can only input pressure oil from one direction, pressurize in a single direction, and form a thrust to push the plunger to move. The return trip of the plunger depends on the plunger itself to fall, and some rely on the spring to push back to the original position. Usually used plunger type stroke adjustable cylinder, its inner hole does not need mechanical finishing, as long as the plunger round grinding can be assembled.

Answers to some questions about stroke adjustable cylinder:

Can pneumatic cylinder be used as hydraulic cylinder?
The pneumatic cylinder can only be used for pressure below 1MPA, and if it is used for hydraulic, the pressure should be under 1MPA, which may not meet the strength requirements. And the seals should use fluorine rubber to avoid corrosion. But pneumatic cylinder used as hydraulic cylinder is not whimsical, in fact, there is such a use. The pneumatic system has a natural defect, that is, the speed is unstable, especially in the case of low speed. The hydraulic pressure is very stable, if you do not want to buy a set of hydraulic system, while the strength of the cylinder is not large, you can use compressed air to push the hydraulic oil, with hydraulic oil to drive the cylinder, The force is the same as compressed air, but very smooth.

How to control the speed of the hydraulic cylinder?
The speed of the hydraulic cylinder is only related to the flow, so the control speed is to control the flow of the hydraulic oil, which is generally adjusted by the throttle valve in the system.