Release time：2023-11-12 15:29:05 Hits： Current position: Home > News
This article mainly introduces:
Hungary hydraulic cylinder,stern plate hydraulic cylinder manufacturer,stern plate hydraulic cylinder
(Hungary stern plate hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）
stern plate hydraulic cylinder are widely used in Hungary，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed stern plate hydraulic cylinder for customers from Hungary.
When the stern plate hydraulic cylinder needs to be stored for a period of time, please follow the recommended methods: The stern plate hydraulic cylinder should be stored in a dry, clean, non-corrosive gas indoor environment, pay attention to protect the stern plate hydraulic cylinder from internal corrosion and external damage. If the indoor requirements cannot be met, the hardened and well-drained ground should be cushioned at least 30cm, and the upper part should be covered with waterproof storage. The oil stern plate hydraulic cylinder should not be in direct contact with water vapor for a long time. The stern plate hydraulic cylinder should be placed as vertically as possible with the piston rod facing up, which minimizes corrosion due to possible condensation in the stern plate hydraulic cylinder and permanent deformation of the seal due to the piston and rod weight. (When the shield is stored in the shield machine, the support shoe is placed upward). Keep the oil port protective cover until the pipe is connected. For long-term storage, the protection should be added on both sides of the piston of the stern plate hydraulic cylinder Before working, the stern plate hydraulic cylinder must be run repeatedly with low pressure (greater than the starting pressure) to discharge the air in the stern plate hydraulic cylinder before normal work. The oil inlet and outlet and the joint must be tightly fastened with a combination pad to prevent oil leakage.
stern plate hydraulic cylinder daily maintenance, should focus on checking whether the piston rod surface roughness and shape and position tolerance meet the technical requirements, if the piston rod bending should be calibrated to meet the requirements or according to the physical mapping, manufactured by a professional manufacturer. If the piston rod surface coating wear, slip damage, local spalling can be adopted to remove the coating, re-chrome surface processing process.
stern plate hydraulic cylinder piston rod material introduction: In general, we use 45 steel to produce stern plate hydraulic cylinder piston rod. It has a large impact force when it is used, and some good performance steel are also used in the heavy load transmission. In order to have enough work intensity when using, and can ensure normal use, this is still more critical to have a detailed understanding of the material.
The stern plate hydraulic cylinder can not be used as grounding electrode to avoid electric damage to the piston rod.
What is the relationship between medium cylinder and side cylinder ratio of forklift truck?
The middle cylinder and the side cylinder seem to have no relationship, as long as the lifting speed required by the design can be ensured, but the diameter of the cylinder can not be too thin, so as to avoid the middle cylinder acting first when the high gantry vibration lifting, and then the two cylinders acting again.
The cylinder is moving too fast. I want to slow it down. What can I do?
The hydraulic cylinder is the execution action, and the power source is the hydraulic system. The cylinder speed is too fast, indicating that the system flow is large, the hydraulic system has a hydraulic valve responsible for speed control function, method: 1, by adjusting the speed control valve to reduce the speed; 2, the speed control valve has been adjusted to the lowest, indicating that the hydraulic system design flow is too high, the need to re-configure the hydraulic system according to demand, or the cylinder diameter is changed.
Add Wechat