hydraulic support cylinder Sold to Kazakhstan

This article mainly introduces:

Kazakhstan hydraulic cylinder,hydraulic support cylinder manufacturer,hydraulic support cylinder

(Kazakhstan hydraulic support cylinder,produced by Hengyu Hydraulic Cylinder Factory）

hydraulic support cylinder are widely used in Kazakhstan，because of long service life，smooth movement，high work efficiency.So our company has designed hydraulic support cylinder for customers from Kazakhstan.

Introduction to hydraulic support cylinder:

After the hydraulic support cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.

The main role of the hydraulic support cylinder: the hydraulic support cylinder is an executive element in the hydraulic transmission system, which is an energy conversion device that converts hydraulic energy into mechanical energy. The hydraulic motor realizes continuous rotary motion, while the hydraulic support cylinder realizes reciprocating motion. The structure of the hydraulic support cylinder has three categories: piston hydraulic support cylinder, plunger hydraulic support cylinder, swing hydraulic support cylinder, piston hydraulic support cylinder and plunger hydraulic support cylinder to achieve reciprocating linear motion, output speed and thrust, swing hydraulic support cylinder to achieve reciprocating swing, output angular speed (speed) and torque. In addition to the single use of the hydraulic support cylinder, two or more can be combined or used in combination with other mechanisms. To fulfill a special function. The hydraulic support cylinder has simple structure and reliable operation, and has been widely used in the hydraulic system of machine tools.

The definition of the minimum starting pressure of the hydraulic support cylinder refers to the minimum working pressure of the hydraulic support cylinder in the no-load state, which is a comprehensive index reflecting the manufacturing and assembly accuracy of the hydraulic support cylinder parts and the size of the sealing friction.

hydraulic support cylinder installation precautions: Before installing the hydraulic support cylinder into the system, the parameters on the hydraulic support cylinder label should be compared with the parameters when ordering. The base of the hydraulic support cylinder must have sufficient stiffness, otherwise the hydraulic support cylinder will bend upward into a bow when pressurized, so that the piston rod will bend.

Answers to some questions about hydraulic support cylinder:

What is hydraulic cylinder？ How to use hydraulic cylinder？ what is the application of hydraulic cylinder?
Hydraulic cylinder is the hydraulic actuator that converts hydraulic energy into mechanical energy and does linear reciprocating movement (or swing movement). It is simple in structure and reliable in operation. When it is used to achieve reciprocating movement, the deceleration device can be eliminated, and there is no transmission gap, and the movement is smooth, so it is widely used in various mechanical hydraulic systems. The output force of the hydraulic cylinder is proportional to the effective area of the piston and the pressure difference between the two sides. The hydraulic cylinder is basically composed of cylinder body, cylinder head, piston, piston rod, sealing device, buffer device and exhaust device. Buffer device and exhaust device depending on the specific application, other devices are essential. Hydraulic cylinders are mainly used in machinery.

What should we pay attention to when using the cylinder?
When using the cylinder, we should pay attention to the environment and temperature in which it is located as follows: 1. Before working, the hydraulic cylinder must carry out several reciprocating movements under low pressure (greater than the starting pressure), and work normally after removing the gas in the cylinder. 2. Precautions when removing the hydraulic cylinder: ① The pressure in the hydraulic circuit is reduced to zero before disassembly. ② The screw thread at the top of the piston rod should be prevented from damage when disassembling. ③ Due to the different structure and size of the hydraulic cylinder, the order of disassembly is also slightly different. Generally, the fastening bolt of the end cover should be loosened first. Internal card chain card key application special tools.