stacker cylinder Sold to Uzbekistan

This article mainly introduces:

Uzbekistan hydraulic cylinder,stacker cylinder manufacturer,stacker cylinder

(Uzbekistan stacker cylinder,produced by Hebei Hengyu company）

stacker cylinder are widely used in Uzbekistan，because of long service life，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed stacker cylinder for customers from Uzbekistan.

Introduction to stacker cylinder:

The meaning of the stacker cylinder model marked by the stacker cylinder manufacturer: for example, 160/100-1150, its meaning: from a professional point of view, 160 refers to the stacker cylinder diameter, which is 160mm, and the 100 behind refers to the rod diameter, which is 100mm. The 1150 refers to the stacker cylinder stroke, which is 1150mm. Therefore, on this point, we should have a correct understanding and can not make mistakes.

When using the stacker cylinder product, be sure to operate safely in accordance with the specification documents provided by the manufacturer, and pay attention to protecting the stacker cylinder block. If the stacker cylinder block is damaged, it will cause adverse consequences: ① The material debris extruded from the scratch groove will be embedded in the seal, which may cause new scratch area marks while damaging the working parts of the seal during operation. ② Deterioration of the surface roughness of the inner wall of the stacker cylinder, increase friction, easy to produce crawling phenomenon. ③ Increase the internal leakage of the stacker cylinder, so that the working efficiency of the stacker cylinder is reduced.

The difference between the integral stacker cylinder and the split stacker cylinder: The integral stacker cylinder and the split stacker cylinder in the stacker cylinder are two different stacker cylinders, and they are very different. The whole stacker cylinder, which is cast in one body, is not prone to problems such as oil leakage; The split stacker cylinder is welded twice, so if it is not handled well at the welding, it is prone to problems such as oil leakage and stacker cylinder damage. Therefore, it is obvious that the answer to this question is for difference.

The coordination of the sliding parts of the stacker cylinder itself should not be too tight, the sealing friction force should not be too large, and H8 / f8 coordination should be selected between the piston rod and the guide sleeve; Check whether the size of the sealing ring is processed strictly according to the standard; If the V-shaped sealing ring is used, the sealing friction should be adjusted to a moderate degree.

Answers to some questions about stacker cylinder:

What are the connection methods of the hydraulic cylinder? The connection modes of the cylinder and the actuator are earring connection, hinge shaft connection, thread connection, etc. The connection modes of tubing and cylinder are threaded connection, flange connection, etc.

What is a differential cylinder?
The differential cylinder is by connecting the return oil of the rod cavity through the pipeline, allowing them to flow into the rodless cavity, thereby speeding up the extension speed of the piston rod. In fact, the cylinder is still the cylinder, but the oil circuit is related to the connection. The oil connection mode in which both chambers of a single rod hydraulic cylinder are fed hydraulic oil is called differential connection.