pipe bender hydraulic cylinder Sold to Britain

This article mainly introduces:

Britain hydraulic cylinder,pipe bender hydraulic cylinder manufacturer,pipe bender hydraulic cylinder

(Britain pipe bender hydraulic cylinder,produced by Hebei Hengyu company）

pipe bender hydraulic cylinder are widely used in Britain，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed pipe bender hydraulic cylinder for customers from Britain.

Introduction to pipe bender hydraulic cylinder:

When the pipe bender hydraulic cylinder needs to be disassembled for maintenance due to leakage and other faults, the piston should be moved to the bottom position of the pipe bender hydraulic cylinder, and hard beating and sudden drop are strictly prohibited during disassembly.

The pipe bender hydraulic cylinder is not the same as the pipe bender hydraulic cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the pipe bender hydraulic cylinder can not be used as a high-power power component, but the pipe bender hydraulic cylinder can be used as a relatively large power component, or the pipe bender hydraulic cylinder system can be used.

The definition of the minimum starting pressure of the pipe bender hydraulic cylinder refers to the minimum working pressure of the pipe bender hydraulic cylinder in the no-load state, which is a comprehensive index reflecting the manufacturing and assembly accuracy of the pipe bender hydraulic cylinder parts and the size of the sealing friction.

If the piston rod and pipe bender hydraulic cylinder are stuck or the pipe bender hydraulic cylinder is blocked, at this time, no matter how to operate, the pipe bender hydraulic cylinder does not move or has little action. At this time, check whether the piston and piston rod seal is too tight, whether it enters the dirt and gum deposits: whether the shaft line of the piston rod and the pipe bender hydraulic cylinder is in the center, whether the wearing parts and seals are invalid, and whether the load is too large.

Answers to some questions about pipe bender hydraulic cylinder:

Why is the hydraulic cylinder of the larger excavator arm upside down?
The weight of the excavating arm of a large excavator will be very heavy, and an oil cylinder has two cavities, one is a rod cavity, and the other is a rodless cavity. The lifting force of the excavator is the product of the ortho-projection area of the piston rod cavity by the oil pressure, so the strength of the rodless cavity is much greater than that of the rod cavity. And the parallel bars with the piston rod facing down are also conducive to assembly and future maintenance. So a large excavator has to keep the cylinder facing down.

How long can a hydraulic cylinder work continuously?
If the maintenance is good, the service life can be extended a lot. The life of the cylinder is related to the structure of the cylinder, working pressure, stress state, hydraulic oil cleanliness, oil temperature control, maintenance and preventive measures. For example, the cylinder structure, the inner wall of the cylinder has quilting, rolling, chrome plating and other methods, the sealing parts have polyurethane rings, glay rings, metal sealing rings, etc., different combinations, the life difference is dozens of times. Metallurgical system is a typical cylinder application, in 24 hours of work, a year or more can not be shut down, in the middle of continuous work.