High quality hydraulic equipment manufacturers!
TELL:+8613184968882

press machine hydraulic cylinder Sold to Panama

Release time:2023-11-12 15:30:45 Hits: Current position: Home > News

This article mainly introduces:

Panama hydraulic cylinder,press machine hydraulic cylinder manufacturer,press machine hydraulic cylinder

Panama press machine hydraulic cylinder

(Panama press machine hydraulic cylinder,produced by Hengyu Group)

press machine hydraulic cylinder are widely used in Panama,because of no transmission clearance,powerful torque,clever hydraulic energy conversion.So our company has designed press machine hydraulic cylinder for customers from Panama.

Introduction to press machine hydraulic cylinder:

press machine hydraulic cylinder can not drive the load troubleshooting: oil pressure is too low. press machine hydraulic cylinder selection specifications are too small. Leakage in press machine hydraulic cylinder or associated hydraulic system element.

If the press machine hydraulic cylinder piston rod is found to be worn, it can be brushed and plated first, then ground, and finally adjust the mating accuracy of the piston rod and the guide sleeve. At this time, the guide sleeve can be properly redrilled or the guide sleeve can be re-turned. When making the above repairs, remember to replace various rubber seals in time.

Under normal circumstances, the press machine hydraulic cylinder is composed of the rear end cover, body, piston, piston rod and front end cover and other main parts. In order to prevent the working medium from leaking out of the press machine hydraulic cylinder or from the high pressure chamber to the low pressure chamber, a sealing device (sealing ring) is arranged between the press machine hydraulic cylinder and the end cover, the piston and the piston rod, the piston and the press machine hydraulic cylinder, the piston rod and the front end cover. A dustproof device is also provided on the outside of the front end cover. In order to prevent the piston from impacting the end cap when it moves rapidly to the end of the stroke, the end of the press machine hydraulic cylinder can also be provided with a buffer device. If necessary, the exhaust device should be set in order to exhaust.

After the press machine hydraulic cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.

Answers to some questions about press machine hydraulic cylinder:

What parameters do I need to provide when purchasing hydraulic cylinders?
The main technical parameters of the hydraulic cylinder: 1. Cylinder diameter; Cylinder diameter, inner diameter size; 2. Piston rod diameter; 3. Cylinder stroke; 4. Cylinder pressure; The working pressure of the cylinder is often calculated using the test pressure, which is less than 16MPa multiplied by 1.5 and higher than 16 multiplied by 1.255. Import and export diameter and thread parameters; 6. Whether there is buffer; According to the working conditions, the piston rod extension contraction is generally buffered if the impact is large. 7. Installation method of oil cylinder, etc.

What is the problem that the cylinder stroke is not in place?
1. Mechanical cause: the piston rod bends; If there is a synchronous cylinder, the stroke of the two cylinders may be different. 2. Hydraulic reason: the system back pressure is too large; The actuator load increases while the system pressure decreases. The electric is not sent, the reversing valve is not reset or stuck, the oil is too dirty, there is gas in the system, the external inertia load is too large, and the cylinder stroke is not in place.

Back to list Recommended article

Leave a message if you have any questions.

Send
Email

Email:hsslrubbertech@gmail.com7x24 hours

Glad to receive your consultation!:

Service
Tel

+8613184968882
7x24hours service

Add
Wechat

Add Wechat
TOP