retractable cylinder Sold to Malaysia

This article mainly introduces:

Malaysia hydraulic cylinder,retractable cylinder manufacturer,retractable cylinder

(Malaysia retractable cylinder,produced by Hengyu Hydraulic Cylinder Factory）

retractable cylinder are widely used in Malaysia，because of simple structure and reliable operation，powerful torque，clever hydraulic energy conversion.So our company has designed retractable cylinder for customers from Malaysia.

Introduction to retractable cylinder:

The retractable cylinder pipe should not be left behind when deburring at both ends after the fixed length processing. In addition, the placement of steel pipes near the site of welding pipeline operations is the cause of welding foreign objects. The pipes placed near the welding operation site should be sealed. It must also be noted that pipe fitting materials should be fully prepared on a dust-free workbench.

Before the retractable cylinder is removed, the system should be unloaded, the loop pressure is zero, the oil source should be cut off, and the oil port should be blocked after the oil port distribution pipe is loosened.

The internal leakage of the retractable cylinder should be prevented when the retractable cylinder is used. The internal leakage of retractable cylinder includes the leakage caused by excessive wear of retractable cylinder block seal, piston rod and seal cover seal and piston seal. The cause of sealing leakage between the piston rod and the seal cover is that the seal is wrinkled, squeezed, torn, worn, aging, deterioration, deformation, etc., and a new seal should be replaced at this time.

When the retractable cylinder is installed, the piston and the retractable cylinder head and other parts have large mass, large size and large inertia, even if there is a lifting equipment auxiliary installation, because the specified clearance is small, no matter how hard it will be put into, therefore, the end of the piston or the retractable cylinder head boss is easy to cause scars when it hits the inner surface of the retractable cylinder wall. The solution to this problem: for a large number of small products, the use of autocratic assembly oriented tools during installation; For heavy, thick and large large and medium-sized retractable cylinders, only careful and careful operation can be avoided.

Answers to some questions about retractable cylinder:

Why does the hydraulic cylinder go up to the top and then slowly go down?
Leakage in the cylinder or the hydraulic valve that controls the cylinder, can be replaced and removed. Or add a pressure retaining valve to the hydraulic system to ensure pressure.

How to judge the leakage in the cylinder?
Common judgment method: In the production site, people make full use of watching, listening, smelling, touching and other sensory ways, by observing that the cylinder can not move or delay the action or feel the oil temperature change, vibration and noise, etc., and then judge whether the cylinder has internal leakage according to experience. Another method commonly used in the field is to extend the cylinder in place to ensure that the cylinder does not have any load and will not retract (to prevent the cylinder from internal leakage accidents), turn off the machine, and then remove the tubing with the rod cavity, and then press the switch that pulls out the cylinder (do not press the wrong switch). If the oil nozzle with the rod cavity drains the cylinder internally, If there's no oil coming out, you have to think about something else going wrong.