pressure plate hydraulic cylinder Sold to El Salvador

This article mainly introduces:

El Salvador hydraulic cylinder,pressure plate hydraulic cylinder manufacturer,pressure plate hydraulic cylinder

(El Salvador pressure plate hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

pressure plate hydraulic cylinder are widely used in El Salvador，because of no need for deceleration device，long service life，smooth movement.So our company has designed pressure plate hydraulic cylinder for customers from El Salvador.

Introduction to pressure plate hydraulic cylinder:

The pressure plate hydraulic cylinder pipe should not be left behind when deburring at both ends after the fixed length processing. In addition, the placement of steel pipes near the site of welding pipeline operations is the cause of welding foreign objects. The pipes placed near the welding operation site should be sealed. It must also be noted that pipe fitting materials should be fully prepared on a dust-free workbench.

Protection of the pressure plate hydraulic cylinder surface: During the dismantling process, safety protection should be carried out on the pressure plate hydraulic cylinder to prevent objects from falling and welding slag from falling to the surface, causing damage to the pressure plate hydraulic cylinder surface. In the process of propulsion, the damaged pipe segments should be prevented from falling and smashing, and the slurry remaining on the surface of the pressure plate hydraulic cylinder should be cleaned up in time.

There are some honeycomb holes in the inner wall of the pressure plate hydraulic cylinder, piston or piston rod surface. How is this formed? When we repair the pressure plate hydraulic cylinder, we can see that there are some honeycomb holes on the inner wall of the pressure plate hydraulic cylinder, the piston or the piston rod surface, which are caused by cavitation. Therefore, the cavitation of the pressure plate hydraulic cylinder is targeted to prevent. Is very necessary.

Disassembly pressure plate hydraulic cylinder: When disassembly pressure plate hydraulic cylinder, strictly prevent damage to the screw thread at the top of the piston rod, the screw thread of the pressure plate hydraulic cylinder head and the surface of the piston rod. It should also be noted that the piston cannot be played out from the pressure plate hydraulic cylinder.

Answers to some questions about pressure plate hydraulic cylinder:

What factors does the movement speed of the cylinder in the hydraulic system depend on?
The hydraulic system should be the piston movement in the cylinder, and the speed should also be the speed of the piston, according to the piston speed formula: v=4qm/pai*(D^2-d^2) where q is the flow rate of the input hydraulic cylinder, m is the volumetric efficiency of the hydraulic cylinder, D, d is the diameter of the piston and piston rod, because other factors are determined, the movement speed of the cylinder depends on the flow rate.

Cylinder pressure calculation formula
The pressure of the cylinder at work is determined by the load, and the pressure of the physical force is equal to the force divided by the area of action (that is, P=F/S). If you want to calculate the output force of the cylinder, you can calculate it according to the formula: Set the radius of the piston (that is, the cylinder) is R (unit mm) the radius of the piston rod is r (unit mm) the working pressure P (unit MPa) the thrust of the cylinder F push =3.14*R*R*P (unit N) The pulling force of the cylinder F pull =3.14* (R*R-r* R) *P (unit N).