child hydraulic cylinder Sold to Switzerland

This article mainly introduces:

Switzerland hydraulic cylinder,child hydraulic cylinder manufacturer,child hydraulic cylinder

(Switzerland child hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

child hydraulic cylinder are widely used in Switzerland，because of long service life，smooth movement，high work efficiency.So our company has designed child hydraulic cylinder for customers from Switzerland.

Introduction to child hydraulic cylinder:

The body of the child hydraulic cylinder on the processing process requirements: the body of the child hydraulic cylinder is an important and essential part of the child hydraulic cylinder, because it has an irreplaceable role. The processing requirements for this part are very high, requiring that the surface roughness of the child hydraulic cylinder after processing should reach 0.4-0.8um, and the coaxiality and wear resistance requirements are also very high.

If the piston rod and child hydraulic cylinder are stuck or the child hydraulic cylinder is blocked, at this time, no matter how to operate, the child hydraulic cylinder does not move or has little action. At this time, check whether the piston and piston rod seal is too tight, whether it enters the dirt and gum deposits: whether the shaft line of the piston rod and the child hydraulic cylinder is in the center, whether the wearing parts and seals are invalid, and whether the load is too large.

When the child hydraulic cylinder is in use, once the seal and guide support ring are found to be defective, the seal with the same structural form and appropriate material should be replaced according to the structural form of the child hydraulic cylinder seal to be repaired, so as to minimize the thickness of the oil film between the seal and the sealing surface and reduce the leakage of the seal.

The commonly used buffer structure of the child hydraulic cylinder is composed of a piston boss and a child hydraulic cylinder head groove. When the piston moves close to the child hydraulic cylinder head, it gradually enters the groove, and the oil in the groove is extruded through the gap between the boss and the groove, which increases the oil return resistance, produces the braking effect and realizes the buffer. Generally, a buffer mechanism should be used when the pressure is above 10MP.

Answers to some questions about child hydraulic cylinder:

How many tons can a 10mpa cylinder with a diameter of 100 hold up?
About 8 tons. Algorithm: Cylinder cross-sectional area = π* (100/2) ^2=3.14*2500=7850 square mm = 0.00785 square meters pressure = pressure * Cross-sectional area = 10000000Pa*0.00785 square meters = 78500 n mass = pressure /g = 78500 N ÷9.8 n/kg = 8010 kg = 8.01 Tons.

What is the function of the Reza mounted master cylinder?
The role of the Resa-mounted master cylinder is to pump the concrete from the hopper to the delivery pipe and to provide sufficient concrete outlet pressure so that the concrete can reach the specified location.