track steering cylinder Sold to Libya

This article mainly introduces:

Libya hydraulic cylinder,track steering cylinder manufacturer,track steering cylinder

(Libya track steering cylinder,produced by Hebei Hengyu company）

track steering cylinder are widely used in Libya，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed track steering cylinder for customers from Libya.

Introduction to track steering cylinder:

When the track steering cylinder wear is serious, you can try to use an alloy scraper to shave grooves with a depth of more than 1mm on the surface of the slip injury, then clean the grooves with acetone, apply the adjusted TS311 anti-wear repair agent on the polished surface with the track steering cylinder inner diameter copying plate, and scrape it flat vigorously to ensure compaction and higher than the inner surface of the track steering cylinder. After curing, polish to leave a finishing margin. Finally, the overall size, shape tolerance and roughness of the track steering cylinder can meet the requirements by grinding. However, the life and reliability of this repair track steering cylinder are not high.

track steering cylinder installation precautions: Before installing the track steering cylinder into the system, the parameters on the track steering cylinder label should be compared with the parameters when ordering. The base of the track steering cylinder must have sufficient stiffness, otherwise the track steering cylinder will bend upward into a bow when pressurized, so that the piston rod will bend.

When the long-stroke track steering cylinder rotates horizontally, the piston rod bends due to its own weight, causing the guide sleeve and piston to produce biased load, resulting in track steering cylinder head seal damage, oil leakage, and piston sleep in the track steering cylinder. The following measures can be taken: increase the piston plan to adjust the piston outer circle and process it into a convex drum, so that the piston can self-position, improve the force situation, and reduce and avoid pulling the track steering cylinder; The piston and the piston rod are connected with a spherical joint.

The track steering cylinder pipe should not be left behind when deburring at both ends after the fixed length processing. In addition, the placement of steel pipes near the site of welding pipeline operations is the cause of welding foreign objects. The pipes placed near the welding operation site should be sealed. It must also be noted that pipe fitting materials should be fully prepared on a dust-free workbench.

Answers to some questions about track steering cylinder:

What is hydraulic cylinder？ How to use hydraulic cylinder？ what is the application of hydraulic cylinder?
Hydraulic cylinder is the hydraulic actuator that converts hydraulic energy into mechanical energy and does linear reciprocating movement (or swing movement). It is simple in structure and reliable in operation. When it is used to achieve reciprocating movement, the deceleration device can be eliminated, and there is no transmission gap, and the movement is smooth, so it is widely used in various mechanical hydraulic systems. The output force of the hydraulic cylinder is proportional to the effective area of the piston and the pressure difference between the two sides. The hydraulic cylinder is basically composed of cylinder body, cylinder head, piston, piston rod, sealing device, buffer device and exhaust device. Buffer device and exhaust device depending on the specific application, other devices are essential. Hydraulic cylinders are mainly used in machinery.

Design a hydraulic cylinder, the inner diameter of the cylinder is 100mm, what size of piston rod is best used?
This involves how much speed ratio you need, that is, the area ratio of the rod cavity and the rodless cavity, if the weight is relatively large, it is recommended that the speed ratio choose 2, that is, the piston rod diameter choose 70mm, under normal circumstances, the speed ratio choose 1.46, the piston rod diameter choose 55mm. Of course, there are many factors that affect the diameter of the piston rod, such as stroke, stroke is too long, in order to stabilize the work of the hydraulic cylinder, its diameter also needs to choose a relatively large, sometimes even non-standard products, need to choose according to the actual situation.