High quality hydraulic equipment manufacturers!
TELL:+8613184968882

unidirectional cylinder Sold to Latvia

Release time:2023-11-14 08:41:31 Hits: Current position: Home > News

This article mainly introduces:

Latvia hydraulic cylinder,unidirectional cylinder manufacturer,unidirectional cylinder

Latvia unidirectional cylinder

(Latvia unidirectional cylinder,produced by Hengyu Hydraulic Co., Ltd)

unidirectional cylinder are widely used in Latvia,because of long service life,smooth movement,high work efficiency.So our company has designed unidirectional cylinder for customers from Latvia.

Introduction to unidirectional cylinder:

How to determine the working pressure of the unidirectional cylinder: The pressure depends on the load size (i.e., F) and the type of equipment. The limitations of assembly space, economic conditions and component availability of the actuator should also be considered. In the case of a certain load, it is necessary to increase the structural size of the actuator if the working pressure is low, for some equipment, the size may be limited, and it is not economical from the point of view of material consumption; On the contrary, if the pressure selection is too high, the material, sealing and manufacturing accuracy of the pump, unidirectional cylinder, valve and other components are also required to be high, which will inevitably increase the cost of equipment. In general, for equipment with a fixed size that is not too limited, the pressure can be selected lower, and the walking machinery should be selected higher.

The commonly used buffer structure of the unidirectional cylinder is composed of a piston boss and a unidirectional cylinder head groove. When the piston moves close to the unidirectional cylinder head, it gradually enters the groove, and the oil in the groove is extruded through the gap between the boss and the groove, which increases the oil return resistance, produces the braking effect and realizes the buffer. Generally, a buffer mechanism should be used when the pressure is above 10MP.

When the unidirectional cylinder is kept, do not pay attention to keeping the oil port open, which will produce the condition of accepting foreign bodies at all times, which is absolutely not allowed. Storage must be filled with anti-rust oil or working oil, and plug.

Because of the slightly complex structure of the buffer unidirectional cylinder, sometimes there will be problems, such as when the unidirectional cylinder with the buffer device is started in reverse, the piston often stops temporarily or reverses. Elimination method: The orifice of the check valve is too small, so that the amount of oil entering the buffer chamber is too small, and even a vacuum occurs, so the above fault phenomenon will occur when the buffer plunger leaves the end cover. In this regard, the orifice of the check valve should be increased.

Answers to some questions about unidirectional cylinder:

Why are two cylinders not balanced with the balance valve?
Balancing valve is only suitable for occasions with low synchronous accuracy requirements, and proportional valves are recommended for occasions with high precision requirements.

What diameter cylinder is needed for a force of 5 tons?
It depends on the pressure of your system pump. If the normal working pressure of the system is about 8MPa, then the diameter of the cylinder should be 100 mm.

Back to list Recommended article

Leave a message if you have any questions.

Send
Email

Email:hsslrubbertech@gmail.com7x24 hours

Glad to receive your consultation!:

Service
Tel

+8613184968882
7x24hours service

Add
Wechat

Add Wechat
TOP