steel mill cylinder Sold to Slovakia

This article mainly introduces:

Slovakia hydraulic cylinder,steel mill cylinder manufacturer,steel mill cylinder

(Slovakia steel mill cylinder,produced by Hengyu Hydraulic Co., Ltd）

steel mill cylinder are widely used in Slovakia，because of long service life，smooth movement，high work efficiency.So our company has designed steel mill cylinder for customers from Slovakia.

Introduction to steel mill cylinder:

The pressure of the sliding surface of the steel mill cylinder piston is too large, resulting in sintering. The piston tilts due to the weight of the piston rod, resulting in the phenomenon of non-stiffness, or the pressure of the sliding surface of the piston rises due to the action of the transverse load, which will cause sintering. In the design of the steel mill cylinder must study its working conditions, the length of the piston and bushing and the size of the clearance must be fully paid attention to.

In the case of serious wear on the inner surface of the steel mill cylinder, or when there is a deep longitudinal tensile mark, it should be mapped according to the physical object and re-produced by the professional manufacturer according to the steel mill cylinder manufacturing process for replacement. The steel mill cylinder can also be repaired with TS311 antiwear repair agent. TS311 anti-wear repair agent is mainly used for the repair of worn and slipped metal parts.

steel mill cylinder hydraulic oil selection: The recommended working oil viscosity of the steel mill cylinder is 10 ~ 110cSt (1.8 ~ 15E), ISO VG46 hydraulic oil. The normal working oil temperature is 10 ~ 70℃, and the ambient temperature is in the range of -20 ~ 80℃. When the ambient temperature and service temperature are low, the hydraulic oil with lower viscosity can be selected.

steel mill cylinder diameter, rod diameter, stroke determination: Choose national standards or other standards steel mill cylinder, avoid the selection of non-standard size, otherwise the difficulty of processing and manufacturing costs will be increased. The length of the steel mill cylinder guide is determined by the length of the stroke. Check the strength of steel mill cylinder, piston rod, screw, etc. according to the working pressure or load. At the same time, working pressure, ambient temperature, working medium and running speed are also the key to selecting seals.

Answers to some questions about steel mill cylinder:

How big is the pump and motor for 20 tons of hydraulic cylinder?
According to the working pressure of 25 mpa estimate, the cylinder should use 100mm bore, 63mm piston rod, stroke 40mm. According to 30 reciprocating calculation, the flow rate is about 25 liters/minute. The motor power is 11 kW, want to be cheap, use 25SCY14-1B oil pump can be.

Where is the cylinder used? What is it used for? Can it be used in cars?
Cylinders can be used as actuator in hydraulic system. Such as hydraulic jacks, dump truck box lifting device, dodging (snow) machine loader bucket lifting device. Hydraulic cylinders are also widely used in car cranes. It's all about cars.