unidirectional cylinder Sold to Norway

This article mainly introduces:

Norway hydraulic cylinder,unidirectional cylinder manufacturer,unidirectional cylinder

(Norway unidirectional cylinder,produced by Hengyu Hydraulic Cylinder Factory）

unidirectional cylinder are widely used in Norway，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed unidirectional cylinder for customers from Norway.

Introduction to unidirectional cylinder:

The difference between the plunger unidirectional cylinder and the piston unidirectional cylinder is that the piston in the unidirectional cylinder is replaced by a shaft plunger, which is used in hydraulic transmission requiring a long mechanical stroke, and can only input pressure oil from one direction, pressurize in a single direction, and form a thrust to push the plunger to move. The return trip of the plunger depends on the plunger itself to fall, and some rely on the spring to push back to the original position. Usually used plunger type unidirectional cylinder, its inner hole does not need mechanical finishing, as long as the plunger round grinding can be assembled.

unidirectional cylinder spool stuck or valve hole blocked How to solve: When the flow valve or direction valve spool stuck or valve hole blocked, the unidirectional cylinder prone to misoperation or action failure. At this time, the contamination of the oil should be checked; Check whether dirt or colloidal deposits are stuck in the spool or blocking the valve hole; Check the wear of the valve body, clean and replace the system filter, clean the fuel tank, and replace the hydraulic medium.

Regular maintenance of the unidirectional cylinder includes: regular tightening, unidirectional cylinder fastening screws and gland screws, unidirectional cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the unidirectional cylinder once a year. Clean regularly, the unidirectional cylinder is cleaned every other year, and the seals are replaced while cleaning.

Disassembly unidirectional cylinder: When disassembly unidirectional cylinder, strictly prevent damage to the screw thread at the top of the piston rod, the screw thread of the unidirectional cylinder head and the surface of the piston rod. It should also be noted that the piston cannot be played out from the unidirectional cylinder.

Answers to some questions about unidirectional cylinder:

Two cylinders have a reversing control, if the load of the two cylinders is not the same, how to ensure their synchronization?
The piston rod of the cylinder is required to extend synchronization: install A shunt collector valve or synchronous motor at port A of the direction control valve, and then connect the two outlets of the shunt collector valve to the rod-free cavity of the two cylinders respectively. It is required that the outlet of the diverter collector valve is connected to the rod cavity of the two cylinders respectively when the piston rod is withdrawn in synchronization. The synchronization performance depends on the quality of the diverter valve and the leakage of the hydraulic system.

What is the meaning of dead volume in hydraulic cylinder?
Closed volume, also known as dead zone volume Positive displacement pump is dependent on the change of sealing working volume to achieve suction and pressure oil, in order not to make the suction and pressure oil cavity interworking, there is an oil sealing area between the suction and pressure oil cavity, when the sealing working volume passes through the oil sealing area, neither pressure oil cavity nor oil suction cavity communication, forming a closed sealing volume. The unloading groove is opened, and the grooving principle is that the sealing volume decreases and the oil pressure chamber is communicated, and the sealing volume increases and the oil suction chamber is communicated.