cylinder with buffer Sold to Slovenia

This article mainly introduces:

Slovenia hydraulic cylinder,cylinder with buffer manufacturer,cylinder with buffer

(Slovenia cylinder with buffer,produced by Hengyu Group）

cylinder with buffer are widely used in Slovenia，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed cylinder with buffer for customers from Slovenia.

Introduction to cylinder with buffer:

The internal leakage of the cylinder with buffer is an important indicator to measure the quality of the cylinder with buffer: the internal leakage of the cylinder with buffer will reduce the volumetric efficiency, increase the temperature rise of the oil, affect the positioning accuracy of the cylinder with buffer, so that the cylinder with buffer can not accurately and stably stop in a certain position of the cylinder with buffer, so it is one of the main indicators of the cylinder with buffer.

Causes and countermeasures of oil cylinder with buffer leakage: Cast iron ring seal allows a certain degree of internal leakage. The impurities in the cylinder with buffer will lead to premature wear of the piston seal, replace the piston seal; If the cylinder with buffer is visibly scarred, the cylinder with buffer must be replaced. It can be pressurized at one end of the cylinder with buffer and opened at the other end of the oil port to observe whether there is obvious internal leakage at the end of the oil port. Most cylinder with buffer piston drift may not come from the cylinder with buffer, the above method to determine the cylinder with buffer without internal leakage is helpful to determine the problem of the hydraulic system related components.

There are some honeycomb holes in the inner wall of the cylinder with buffer, piston or piston rod surface. How is this formed? When we repair the cylinder with buffer, we can see that there are some honeycomb holes on the inner wall of the cylinder with buffer, the piston or the piston rod surface, which are caused by cavitation. Therefore, the cavitation of the cylinder with buffer is targeted to prevent. Is very necessary.

When the cylinder with buffer is installed, the piston and the cylinder with buffer head and other parts have large mass, large size and large inertia, even if there is a lifting equipment auxiliary installation, because the specified clearance is small, no matter how hard it will be put into, therefore, the end of the piston or the cylinder with buffer head boss is easy to cause scars when it hits the inner surface of the cylinder with buffer wall. The solution to this problem: for a large number of small products, the use of autocratic assembly oriented tools during installation; For heavy, thick and large large and medium-sized cylinder with buffers, only careful and careful operation can be avoided.

Answers to some questions about cylinder with buffer:

What is the material of the hydraulic cylinder slider?
Three parts of the hydraulic cylinder are essential, which are: cylinder - cylinder head assembly, piston - piston rod assembly, and sealing device. When you say slider, you mean piston. - Piston rod. Piston materials commonly used gray cast iron, wear-resistant cast iron, aluminum alloy (assembled), etc., can also be used 35 and 45 steel (integral). The piston rod is generally made of 35 and 45 steel. When the impact vibration is large, alloy steel such as 55 steel or 40Cr is used.

Why manual forklift oil cylinder can not lift up?
Manual hydraulic forklift truck often can not be pressed up, there are several reasons: for manual hydraulic truck: 1) There is no hydraulic oil 2) the purity of the oil is not enough 3) the adjusting bolt is too close or the adjusting screw is too tight, so that the valve is always open, 4) there is an air in the hydraulic cylinder. Method: 1) Refueling 2) Oil change 3) air discharge. For manual hydraulic stacker, also called manual lift car 1) Less than the amount of oil 2) impurities in the hydraulic oil, so that the check valve can not be closed. Method 1) Add enough hydraulic oil 2) Remove the cylinder, screw off the bottom plate, remove the impurities in the bottom plate.