plating press hydraulic cylinder Sold to Poland

This article mainly introduces:

Poland hydraulic cylinder,plating press hydraulic cylinder manufacturer,plating press hydraulic cylinder

(Poland plating press hydraulic cylinder,produced by Hengyu Group）

plating press hydraulic cylinder are widely used in Poland，because of no need for deceleration device，high work efficiency，excellent fatigue and impact resistance.So our company has designed plating press hydraulic cylinder for customers from Poland.

Introduction to plating press hydraulic cylinder:

When the hydraulic oil is not pumped into the plating press hydraulic cylinder, it is necessary to check whether the tubing, oil circuit, especially the hose joint has been blocked, and the relevant oil circuit from the plating press hydraulic cylinder to the pump should be checked in turn and blocked; Check whether the seal between the taper valve and the seat of the relief valve is good; Check whether the solenoid valve spring is damaged or whether the solenoid coil is burned out; Whether the oil circuit is switched is insensitive.

When purchasing the plating press hydraulic cylinder, try to clarify the following parameters of the plating press hydraulic cylinder: A. plating press hydraulic cylinder diameter, rod diameter, stroke; B. Working pressure or plating press hydraulic cylinder load; C. Working environment temperature; D. Working medium; E. Operating speed; F. Other parameters, such as connection form, mounting size, etc. In this way, the right plating press hydraulic cylinder type can be found accurately and quickly.

The definition of the minimum stable speed refers to the minimum movement speed of the plating press hydraulic cylinder without crawling phenomenon when the full load is moving, it has no uniform indicator, and the plating press hydraulic cylinder that undertakes different work has different requirements for the minimum stable speed.

How to determine the working pressure of the plating press hydraulic cylinder: The pressure depends on the load size (i.e., F) and the type of equipment. The limitations of assembly space, economic conditions and component availability of the actuator should also be considered. In the case of a certain load, it is necessary to increase the structural size of the actuator if the working pressure is low, for some equipment, the size may be limited, and it is not economical from the point of view of material consumption; On the contrary, if the pressure selection is too high, the material, sealing and manufacturing accuracy of the pump, plating press hydraulic cylinder, valve and other components are also required to be high, which will inevitably increase the cost of equipment. In general, for equipment with a fixed size that is not too limited, the pressure can be selected lower, and the walking machinery should be selected higher.

Answers to some questions about plating press hydraulic cylinder:

What is the HS code of the hydraulic cylinder?
HS code of hydraulic cylinder; 8412210000 8412210000 Linear hydraulic power unit (hydraulic cylinder) 0.12000 0.35000 0.00000 0.17000 0.00000

How many kinds of cylinder seal repair kit are there?
Very much, a wide variety of imported and domestic, J type, UHS, DHS, O-ring, Sterseal, etc., as well as support bars, materials are different, according to the size of the pressure selection is different, the appearance of the structure is different, the size is a variety, maintenance is generally selected according to the needs of the cylinder.