hydraulic forklift cylinder Sold to Turkmenistan

This article mainly introduces:

Turkmenistan hydraulic cylinder,hydraulic forklift cylinder manufacturer,hydraulic forklift cylinder

(Turkmenistan hydraulic forklift cylinder,produced by Hengyu Hydraulic Cylinder Factory）

hydraulic forklift cylinder are widely used in Turkmenistan，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed hydraulic forklift cylinder for customers from Turkmenistan.

Introduction to hydraulic forklift cylinder:

After chrome plating of the piston rod of the hydraulic forklift cylinder, the surface flatness is not fully treated: After chrome plating of the piston rod surface, the method of post-plating polishing should be changed to post-plating polishing. Although it is necessary to increase the thickness of the coating before grinding (generally increased by about 0.02 in the diameter direction), it can remove chrome plating defects well, and test the binding force of the coating. In addition, due to the micro-roughness of the grinding surface, the trough can store lubricating oil, which can improve the wear resistance and extend the service life.

The difference between the integral hydraulic forklift cylinder and the split hydraulic forklift cylinder: The integral hydraulic forklift cylinder and the split hydraulic forklift cylinder in the hydraulic forklift cylinder are two different hydraulic forklift cylinders, and they are very different. The whole hydraulic forklift cylinder, which is cast in one body, is not prone to problems such as oil leakage; The split hydraulic forklift cylinder is welded twice, so if it is not handled well at the welding, it is prone to problems such as oil leakage and hydraulic forklift cylinder damage. Therefore, it is obvious that the answer to this question is for difference.

hydraulic forklift cylinder head explanation: low pressure castings, medium and low pressure with HT300 gray iron, medium and high pressure with 35, 45 steel. When the hydraulic forklift cylinder head itself is the guide sleeve of the piston rod, the hydraulic forklift cylinder head is best cast iron. At the same time, brass, bronze or other wear-resistant materials should be fused on the guide surface. If the guide sleeve is pressed into the hydraulic forklift cylinder head, the guide sleeve shall be wear-resistant cast iron, bronze or brass.

The quality of the hydraulic forklift cylinder can not be ignored in the purchase of the hydraulic forklift cylinder. The hydraulic forklift cylinder is the main component of the hydraulic forklift cylinder, the single pillar for mining, the hydraulic support, the gun tube and other products, and its processing quality directly affects the life and reliability of the entire product. hydraulic forklift cylinder processing requirements are high, its internal surface roughness requirements are Ra0.4 ~ 0.8μm, the coaxiality, wear resistance requirements are strict. The basic feature of hydraulic forklift cylinder is deep hole processing, which has always troubled the processing personnel.

Answers to some questions about hydraulic forklift cylinder:

What brand of hydraulic cylinder seal ring is best?
Depending on the specific product, the world famous seal brands are NOK, CFW, PARKER, TSS, WKF, DINGZING DZ, ASTON, HALLITE, TECNOLAN and so on.

What hydraulic valve is used to control a cylinder back and forth?
Direction valve is available. Direction valve includes electromagnetic directional valve, manual directional valve, check valve, hydraulic control check valve, the specific choice of which direction valve, you need to see the use of conditions.