single rack cylinder Sold to Congo

This article mainly introduces:

Congo hydraulic cylinder,single rack cylinder manufacturer,single rack cylinder

(Congo single rack cylinder,produced by Hengyu Hydraulic Co., Ltd）

single rack cylinder are widely used in Congo，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed single rack cylinder for customers from Congo.

Introduction to single rack cylinder:

Factors that should be considered when selecting the oil seal in the single rack cylinder: some specific factors should be taken into account when selecting the oil seal in the single rack cylinder, so as to have correct consideration and get accurate results, and then avoid wrong selection. The factors and aspects that should be taken into account are eight: single rack cylinder diameter, piston rod diameter, piston rod and piston groove size, single rack cylinder working pressure, single rack cylinder movement speed, hydraulic system oil temperature and single rack cylinder working environment.

How to repair the single rack cylinder body when it is damaged: When the single rack cylinder has trace deformation and shallow tensile marks, the single rack cylinder is repaired by strong honing process. The heavy honing process can repair single rack cylinders up to 2.5 times out of tolerance than the original tolerance. It honed the parts with excessive size or shape error through a powerful honing machine, so that the overall size, shape tolerance and roughness of the single rack cylinder can meet the technical requirements.

If air enters the hydraulic system, the single rack cylinder will not operate normally, mainly because there is a leak in the system. At this time, check the liquid level of the hydraulic tank, the seals and fittings on the oil suction side of the hydraulic pump, and whether the oil suction filter is too dirty. If so, the hydraulic oil should be replenished, seals and fittings should be treated, and the coarse filter element should be cleaned or replaced.

The single rack cylinder requires that the filtration accuracy of the system is not less than the 80um, and the oil pollution should be strictly controlled, the oil should be kept clean, the performance of the oil should be checked regularly, and the necessary fine filtration and replacement of new working oil should be carried out.

Answers to some questions about single rack cylinder:

Where's the hydraulic cylinder bleed valve?
There is a vent hole at the top of the cylinder next to the intake pipe. Generally, it can be used, and the air in the cylinder can be naturally drained after several moves.

When the hydraulic cylinder changes from fast to slow, how can the slow speed become more even and the speed can be adjusted?
Reversing valve set 2 reversing valves. The back of one valve goes directly to the cylinder, running at full speed for fast action. Add a speed control valve behind the other valve, and then connect to the cylinder to achieve slow action, you can adjust the opening of the speed control valve, to achieve the speed of the cylinder can be adjusted. An import speed control valve to more than 1,000 yuan, if you think it is too expensive, you can also use the throttle valve instead. However, the throttle valve is greatly affected by the load change.