cylinder with sensor Sold to Bahrain

This article mainly introduces:

Bahrain hydraulic cylinder,cylinder with sensor manufacturer,cylinder with sensor

(Bahrain cylinder with sensor,produced by Hengyu Hydraulic Co., Ltd）

cylinder with sensor are widely used in Bahrain，because of long service life，high work efficiency，smooth movement.So our company has designed cylinder with sensor for customers from Bahrain.

Introduction to cylinder with sensor:

The scar on the sliding surface of the cylinder with sensor piston will transfer with use. Before the piston is installed, there are scars on its sliding surface, which are installed intact and untreated, and these scars will in turn scratch the inner surface of the cylinder with sensor wall. Therefore, before installation, these scars must be fully repaired.

In order to ensure the service life of the cylinder with sensor, the medium used must not be mixed with impurities and stolen goods, so as to avoid scratching the inner arm of the cylinder with sensor, causing damage to the seal and causing leakage in the cylinder with sensor. It is required that the filtration accuracy of the system is not less than 80μm, the oil pollution is strictly controlled, the hydraulic oil is kept clean, the performance of the hydraulic oil is regularly checked, and the necessary fine filtration or replacement of the new working hydraulic oil is carried out.

The piston seal of the cylinder with sensor is the main element to prevent leakage in the cylinder with sensor. For the lip seal, it should focus on checking whether the lip edge is bruised and worn, and for the combination seal, it should focus on checking the wear of the sealing surface, and then determine whether the seal can be used. In addition, it is necessary to check whether the static seal between the piston and the piston rod is crushed. The piston rod seal should focus on checking the wear of the seals and supporting rings.

When installing the cylinder with sensor pipe, the pipe should be cleaned after installation, and should not pass through the cylinder with sensor block, and the by-pass pipe must be installed in front of the oil port of the cylinder with sensor block. This is important. Otherwise, the foreign body in the pipeline will enter the cylinder with sensor, and once it enters, it is difficult to exclude it, but it becomes a foreign body transported to the cylinder with sensor. Moreover, when cleaning, the removal method of foreign bodies entered in the installation pipeline operation should be considered. In addition, the corrosion in the pipe should be pickling and other procedures before the pipe installation, and the rust must be completely removed.

Answers to some questions about cylinder with sensor:

The inner diameter of the injection cylinder is 203.2mm and the diameter of the screw is 63.5mm. What is the enhancement ratio?
Oil pressure multiplied by the cross-sectional area of the cylinder is equal to the theoretical output force value, and then multiplied by the efficiency of the cylinder is equal to the actual output force value, and the oil pressure can be calculated by inverting the value input.

What is st represented in the cylinder formula?
St is the original unit of kinematic viscosity, the abbreviation of Stokes, that is, Stokes, short for S. cm2/s has now been used. 1 s (St) = 10^-4m2/s.