push plate cylinder Sold to Panama

This article mainly introduces:

Panama hydraulic cylinder,push plate cylinder manufacturer,push plate cylinder

(Panama push plate cylinder,produced by Hengyu Group）

push plate cylinder are widely used in Panama，because of excellent fatigue and impact resistance，smooth movement，high work efficiency.So our company has designed push plate cylinder for customers from Panama.

Introduction to push plate cylinder:

The assembly work of the push plate cylinder has a great impact on the quality of the push plate cylinder: each part must be carefully cleaned before assembly; To correctly install the sealing device everywhere: when installing the sealing ring, pay attention to its installation direction to avoid oil leakage due to installation, and its lip should be equipped with a pressure oil chamber. In addition, because it is a YX-shaped sealing ring, it is necessary to pay attention to distinguish between shaft and hole use, do not install wrong; Because the sealing device is matched with the sliding surface, an appropriate amount of hydraulic oil should be applied during assembly; The special wrench should be used when the threaded coupling is tightened, and the torque should meet the standard requirements; After the piston and piston rod are assembled, it is necessary to measure whether the coaxiality and straightness on the full length are out of whack. After assembly, there should be no blocking sensation and uneven resistance when the piston assembly moves.

push plate cylinder head explanation: low pressure castings, medium and low pressure with HT300 gray iron, medium and high pressure with 35, 45 steel. When the push plate cylinder head itself is the guide sleeve of the piston rod, the push plate cylinder head is best cast iron. At the same time, brass, bronze or other wear-resistant materials should be fused on the guide surface. If the guide sleeve is pressed into the push plate cylinder head, the guide sleeve shall be wear-resistant cast iron, bronze or brass.

push plate cylinder abnormal sound, hysteresis phenomenon cause and elimination method: the piston rod is extended with abnormal sound and hysteresis, if the push plate cylinder is placed for a period of time, the push plate cylinder may enter the air, and the movement can be normal after dozens of repeated movements. If it still cannot be eliminated, check whether the load is aligned with the axis of the piston rod; Retracted piston rod installation helps to align the load with the piston rod. If the flow is unstable, it will also lead to abnormal movement of the piston rod. Check the relevant components of the hydraulic system.

The definition of the minimum stable speed refers to the minimum movement speed of the push plate cylinder without crawling phenomenon when the full load is moving, it has no uniform indicator, and the push plate cylinder that undertakes different work has different requirements for the minimum stable speed.

Answers to some questions about push plate cylinder:

What is the HS code of the hydraulic cylinder?
HS code of hydraulic cylinder; 8412210000 8412210000 Linear hydraulic power unit (hydraulic cylinder) 0.12000 0.35000 0.00000 0.17000 0.00000

What does cylinder hob125*100 mean?
HOB is a series of hydraulic cylinder products, the use of pressure 14MPA, tie rod structure. 125 refers to the diameter of the cylinder and 100 refers to the stroke. The unit is millimeters.