stroke adjustable cylinder Sold to Ecuador

This article mainly introduces:

Ecuador hydraulic cylinder,stroke adjustable cylinder manufacturer,stroke adjustable cylinder

(Ecuador stroke adjustable cylinder,produced by Hengyu Hydraulic Cylinder Factory）

stroke adjustable cylinder are widely used in Ecuador，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed stroke adjustable cylinder for customers from Ecuador.

Introduction to stroke adjustable cylinder:

stroke adjustable cylinder diameter, rod diameter, stroke determination: Choose national standards or other standards stroke adjustable cylinder, avoid the selection of non-standard size, otherwise the difficulty of processing and manufacturing costs will be increased. The length of the stroke adjustable cylinder guide is determined by the length of the stroke. Check the strength of stroke adjustable cylinder, piston rod, screw, etc. according to the working pressure or load. At the same time, working pressure, ambient temperature, working medium and running speed are also the key to selecting seals.

When the hydraulic oil is not pumped into the stroke adjustable cylinder, it is necessary to check whether the tubing, oil circuit, especially the hose joint has been blocked, and the relevant oil circuit from the stroke adjustable cylinder to the pump should be checked in turn and blocked; Check whether the seal between the taper valve and the seat of the relief valve is good; Check whether the solenoid valve spring is damaged or whether the solenoid coil is burned out; Whether the oil circuit is switched is insensitive.

We can not just consider the price and ignore the quality when we purchase the stroke adjustable cylinders. Now some manufacturers produce unqualified products in order to reduce costs, the piston rod is not adjusted, the rod coating is not enough, the stroke adjustable cylinder finish can not reach, the guide sleeve should use copper, but instead of ductile iron, although the cost is reduced, the quality of the stroke adjustable cylinder is not required.

When installing the stroke adjustable cylinder pipe, the pipe should be cleaned after installation, and should not pass through the stroke adjustable cylinder block, and the by-pass pipe must be installed in front of the oil port of the stroke adjustable cylinder block. This is important. Otherwise, the foreign body in the pipeline will enter the stroke adjustable cylinder, and once it enters, it is difficult to exclude it, but it becomes a foreign body transported to the stroke adjustable cylinder. Moreover, when cleaning, the removal method of foreign bodies entered in the installation pipeline operation should be considered. In addition, the corrosion in the pipe should be pickling and other procedures before the pipe installation, and the rust must be completely removed.

Answers to some questions about stroke adjustable cylinder:

How to calculate the inner diameter of the hydraulic cylinder?
These two parameters need the following information to decide: 1, pump displacement, speed (to get the actual output flow of the pump) 2, three and time requirements (lift time, drop time takes a few seconds) and then view the close cylinder series according to the results. Select the right cylinder.

Why does the hydraulic cylinder not return?
For a spring return cylinder, it is possible that 1, the spring is damaged. You can check it for processing. 2, the oil in the oil path is not unloaded, causing it to be unable to reset. 3, the cylinder piston is dead, resulting in no position. For double-acting cylinders, it is possible to: 1, the spool is not reversed, or is not changed to the correct position, check whether the reversing valve is normal (and whether there is electricity). 2, the cylinder piston is dead, resulting in no position, check and treatment can be. 3, the return oil pressure is insufficient, the inlet oil is not unloaded, the operation is not smooth. For reference only.