pipe bender hydraulic cylinder Sold to Ireland

This article mainly introduces:

Ireland hydraulic cylinder,pipe bender hydraulic cylinder manufacturer,pipe bender hydraulic cylinder

(Ireland pipe bender hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

pipe bender hydraulic cylinder are widely used in Ireland，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed pipe bender hydraulic cylinder for customers from Ireland.

Introduction to pipe bender hydraulic cylinder:

When installing the pipe bender hydraulic cylinder pipe, the pipe should be cleaned after installation, and should not pass through the pipe bender hydraulic cylinder block, and the by-pass pipe must be installed in front of the oil port of the pipe bender hydraulic cylinder block. This is important. Otherwise, the foreign body in the pipeline will enter the pipe bender hydraulic cylinder, and once it enters, it is difficult to exclude it, but it becomes a foreign body transported to the pipe bender hydraulic cylinder. Moreover, when cleaning, the removal method of foreign bodies entered in the installation pipeline operation should be considered. In addition, the corrosion in the pipe should be pickling and other procedures before the pipe installation, and the rust must be completely removed.

The pipe bender hydraulic cylinder pipe should not be left behind when deburring at both ends after the fixed length processing. In addition, the placement of steel pipes near the site of welding pipeline operations is the cause of welding foreign objects. The pipes placed near the welding operation site should be sealed. It must also be noted that pipe fitting materials should be fully prepared on a dust-free workbench.

The pipe bender hydraulic cylinder should be used correctly and maintained regularly. The pipe bender hydraulic cylinder should be deflated before use, the buffer regulating valve should be adjusted to a reasonable position, the cleanliness of the oil should be checked regularly, the dust on the pipe bender hydraulic cylinder should be cleaned regularly, and attention should be paid to waterproof and fireproof.

If air enters the hydraulic system, the pipe bender hydraulic cylinder will not operate normally, mainly because there is a leak in the system. At this time, check the liquid level of the hydraulic tank, the seals and fittings on the oil suction side of the hydraulic pump, and whether the oil suction filter is too dirty. If so, the hydraulic oil should be replenished, seals and fittings should be treated, and the coarse filter element should be cleaned or replaced.

Answers to some questions about pipe bender hydraulic cylinder:

There are four cylinders in the front top of the dump truck. When the second cylinder is lifted to half the height, it suddenly falls back more than 30 cm or so, and the cylinder continues to lift.
The problem is the cylinder, the second section of the different strength of the heart. When the oil supply resistance is small, the first out, when the power is not moving, the cylinder needs to be strong, because the second section needs to pop it out after a while when the pressure is large, the oil can not keep up, so it falls back, and the oil continues to keep up.

What are the requirements for hydraulic cylinder assembly? ① The installation of the cylinder should be solid and reliable. In order to prevent the influence of thermal expansion, in the case of large stroke and hot working conditions, one end of the cylinder must be kept floating.② pipe connection shall not be relaxed.③ The mounting surface of the hydraulic cylinder and the sliding surface of the piston rod should maintain sufficient parallelism and perpendicality.④ The central axis of the moving cylinder should be concentric with the center line of the load force, otherwise it will cause lateral force, which is easy to wear the seal And piston damage. The greater the distance between the supporting points of the piston rod, the smaller its wear. For the hydraulic cylinder of the moving object, the installation should keep the cylinder parallel with the moving object, and the degree of non-parallelism is generally not greater than 0.05mm/m. ⑤The sealing ring should not be installed too tightly, especially the U-shaped sealing ring.