spring return cylinder Sold to Chile

This article mainly introduces:

Chile hydraulic cylinder,spring return cylinder manufacturer,spring return cylinder

(Chile spring return cylinder,produced by Hebei Hengyu company）

spring return cylinder are widely used in Chile，because of long service life，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed spring return cylinder for customers from Chile.

Introduction to spring return cylinder:

spring return cylinders in series, parallel and series parallel. Series: In the spring return cylinder, the oil inlet of the subsequent reversing valve is the supply of the previous oil return, and there is no separate oil return circuit connected with the oil return in each valve. Series: In the spring return cylinder, the oil inlet of the subsequent reversing valve is the supply of the previous oil return, and there is no separate oil return circuit connected with the oil return in each valve. Parallel: the pressure oil in the spring return cylinder is connected with the inlet oil of each reversing valve, and the return oil is collected by the return oil circuit. Series parallel: For this one, compared with the simple series and parallel, it is slightly more complicated, but it is not impossible to understand. The series refers to the oil in the spring return cylinder, which is in series form, but can not form a series circuit, and the parallel refers to the oil return circuit of each valve, which is in parallel.

spring return cylinder body inspection: The inner surface of the spring return cylinder and the piston seal are the main factors causing the leakage in the spring return cylinder, if the spring return cylinder has a longitudinal tensile mark, even if the new piston seal is replaced, it can not effectively eliminate the fault, the inner surface of the spring return cylinder mainly checks whether the dimensional tolerance and shape and position tolerance meet the technical requirements, there is no longitudinal tensile mark, and measures the depth of the longitudinal tensile mark, in order to take the corresponding solution.

The definition of the minimum stable speed refers to the minimum movement speed of the spring return cylinder without crawling phenomenon when the full load is moving, it has no uniform indicator, and the spring return cylinder that undertakes different work has different requirements for the minimum stable speed.

When the spring return cylinder is installed, the piston and the spring return cylinder head and other parts have large mass, large size and large inertia, even if there is a lifting equipment auxiliary installation, because the specified clearance is small, no matter how hard it will be put into, therefore, the end of the piston or the spring return cylinder head boss is easy to cause scars when it hits the inner surface of the spring return cylinder wall. The solution to this problem: for a large number of small products, the use of autocratic assembly oriented tools during installation; For heavy, thick and large large and medium-sized spring return cylinders, only careful and careful operation can be avoided.

Answers to some questions about spring return cylinder:

How to calculate multistage cylinder volume?
When the multi-stage cylinder is extended, the largest cylinder is extended first, and when the largest cylinder stroke is completed, the second largest cylinder is extended again, the second largest cylinder stroke is completed, the third largest cylinder is extended again... Therefore, the cylinder extension length is less than the stroke of the largest cylinder, and the volume is the extension length times the inner hole area of the largest cylinder. The cylinder extension length is greater than the maximum cylinder stroke and less than (the largest cylinder stroke + the second largest cylinder stroke), and the volume is the largest cylinder stroke times the internal hole area of the largest cylinder + (the extension length - the largest cylinder stroke) times the second largest cylinder.

Where's the hydraulic cylinder bleed valve?
There is a vent hole at the top of the cylinder next to the intake pipe. Generally, it can be used, and the air in the cylinder can be naturally drained after several moves.