steel mill cylinder Sold to Burma

This article mainly introduces:

Burma hydraulic cylinder,steel mill cylinder manufacturer,steel mill cylinder

(Burma steel mill cylinder,produced by Hengyu Group）

steel mill cylinder are widely used in Burma，because of high work efficiency，long service life，smooth movement.So our company has designed steel mill cylinder for customers from Burma.

Introduction to steel mill cylinder:

steel mill cylinder and hydraulic station selection: Select the type and structure of the steel mill cylinder according to the operation requirements of the main engine. According to the external load force borne by the steel mill cylinder, such as gravity, friction force of the external mechanism, inertia force and working load, determine the load change law of the steel mill cylinder in each stage of the stroke and the power value that must be provided. Determine the diameter of the piston and piston rod according to the working load of the steel mill cylinder and the selected oil working pressure. the flow rate of the hydraulic pump is determined according to the movement speed of the steel mill cylinder, the diameter of the piston and the piston rod.

When the control pressure of the hydraulic system is too low, the steel mill cylinder will appear wrong or no action, because the throttle resistance in the control pipeline may be too large, the flow valve is improperly adjusted, the control pressure is inappropriate, and the pressure source is interfered with. At this time, check the control pressure source to ensure that the pressure is adjusted to the specified value of the system.

The commonly used buffer structure of the steel mill cylinder is composed of a piston boss and a steel mill cylinder head groove. When the piston moves close to the steel mill cylinder head, it gradually enters the groove, and the oil in the groove is extruded through the gap between the boss and the groove, which increases the oil return resistance, produces the braking effect and realizes the buffer. Generally, a buffer mechanism should be used when the pressure is above 10MP.

The machining accuracy of the steel mill cylinder depends on the level of equipment, production technology and testing means. steel mill cylinder processing methods are commonly used in two ways, one is rough boring - fine boring - rolling, generally with 45# seamless steel pipe, this method of processing quality is good, but the cost is high. Another method is to use 20# cold-drawn seamless steel pipe, and then honing, the cost is lower. The piston rod must be adjusted and straightened before processing, and the coating thickness of the piston rod is generally not less than 0.03mm. The piston must be machined in strict accordance with the groove size and tolerance requirements given in the seal manual.

Answers to some questions about steel mill cylinder:

Is rubber or polyurethane better for V-ring of hydraulic cylinder?
The hydraulic cylinder V-type seal ring is better with polyurethane, and chlorine rubber is used for various chemicals and high temperatures, especially when there are wear-resistant requirements, polyurethane rubber is needed. But the price of polyurethane rubber is much more expensive than the price of rubber. However, the V-ring material is most commonly used in nitrile and neoprene rubber, and natural rubber is used for sealing water and air. Butyl rubber is used for non-combustible hydraulic fluids and phosphate ester hydraulic fluids. The advantage is that the price is cheaper than the polyurethane material, and the disadvantage is that it is not wear-resistant and the anti-aging property is relatively poor.

What are the requirements for hydraulic cylinder assembly? ① The installation of the cylinder should be solid and reliable. In order to prevent the influence of thermal expansion, in the case of large stroke and hot working conditions, one end of the cylinder must be kept floating.② pipe connection shall not be relaxed.③ The mounting surface of the hydraulic cylinder and the sliding surface of the piston rod should maintain sufficient parallelism and perpendicality.④ The central axis of the moving cylinder should be concentric with the center line of the load force, otherwise it will cause lateral force, which is easy to wear the seal And piston damage. The greater the distance between the supporting points of the piston rod, the smaller its wear. For the hydraulic cylinder of the moving object, the installation should keep the cylinder parallel with the moving object, and the degree of non-parallelism is generally not greater than 0.05mm/m. ⑤The sealing ring should not be installed too tightly, especially the U-shaped sealing ring.