plating press hydraulic cylinder Sold to Switzerland

This article mainly introduces:

Switzerland hydraulic cylinder,plating press hydraulic cylinder manufacturer,plating press hydraulic cylinder

(Switzerland plating press hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

plating press hydraulic cylinder are widely used in Switzerland，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed plating press hydraulic cylinder for customers from Switzerland.

Introduction to plating press hydraulic cylinder:

When the plating press hydraulic cylinder is disassembled due to oil leakage and other faults, the position of the piston should be moved to any end position of the plating press hydraulic cylinder by applying liquid pressure. Improper tapping and sudden drop should be avoided during disassembly.

Regular maintenance of the plating press hydraulic cylinder includes: regular tightening, plating press hydraulic cylinder fastening screws and gland screws, plating press hydraulic cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the plating press hydraulic cylinder once a year. Clean regularly, the plating press hydraulic cylinder is cleaned every other year, and the seals are replaced while cleaning.

The coordination of the sliding parts of the plating press hydraulic cylinder itself should not be too tight, the sealing friction force should not be too large, and H8 / f8 coordination should be selected between the piston rod and the guide sleeve; Check whether the size of the sealing ring is processed strictly according to the standard; If the V-shaped sealing ring is used, the sealing friction should be adjusted to a moderate degree.

Repair method of small range wear of oil plating press hydraulic cylinder: 1. Use oxygen-acetylene flame to bake the scratched part (master the temperature, avoid surface annealing), bake the oil on the metal surface all the year round until no sparks splash; 2. The scratched part is treated with an Angle grinder, the grinding depth is more than 1 mm, and the groove is polished along the guide rail, preferably a dovetail groove. Scratch both ends of the drilling deeper, change the force situation; 3. Clean the surface with absorbent cotton dipped in acetone or anhydrous ethanol.

Answers to some questions about plating press hydraulic cylinder:

Why is there noise in the hydraulic cylinder of the excavator lift arm?
There is no noise of a normal cylinder, check whether the throttle is ringing, or the mechanical part connected with it is ringing, and the mechanical part can be greased. If it can't be ruled out, disconnect the cylinder from the mechanical part and act alone to see what the situation is.

What does cylinder hob125*100 mean?
HOB is a series of hydraulic cylinder products, the use of pressure 14MPA, tie rod structure. 125 refers to the diameter of the cylinder and 100 refers to the stroke. The unit is millimeters.