High quality hydraulic equipment manufacturers!
TELL:+8613184968882

series synchronous cylinder Sold to Latvia

Release time:2023-11-21 09:55:46 Hits:110 Current position: Home > News

This article mainly introduces:

Latvia hydraulic cylinder,series synchronous cylinder manufacturer,series synchronous cylinder

Latvia series synchronous cylinder

(Latvia series synchronous cylinder,produced by Hengyu Hydraulic Cylinder Factory)

series synchronous cylinder are widely used in Latvia,because of no need for deceleration device,long service life,smooth movement.So our company has designed series synchronous cylinder for customers from Latvia.

Introduction to series synchronous cylinder:

The repair method of the series synchronous cylinder: the repair of the series synchronous cylinder must use brush plating. This is because this repair method can be carried out on site, and the repair effect is good. In this way, loading and transportation can be eliminated to shorten the repair time and improve work efficiency. In addition, the coating obtained by brush plating has good binding force and will not have obvious boundaries. Moreover, the repair surface has high hardness and good wear resistance.

The series synchronous cylinder requires that the filtration accuracy of the system is not less than the 80um, and the oil pollution should be strictly controlled, the oil should be kept clean, the performance of the oil should be checked regularly, and the necessary fine filtration and replacement of new working oil should be carried out.

The series synchronous cylinder can not be used as grounding electrode to avoid electric damage to the piston rod.

The piston seal of the series synchronous cylinder is the main element to prevent leakage in the series synchronous cylinder. For the lip seal, it should focus on checking whether the lip edge is bruised and worn, and for the combination seal, it should focus on checking the wear of the sealing surface, and then determine whether the seal can be used. In addition, it is necessary to check whether the static seal between the piston and the piston rod is crushed. The piston rod seal should focus on checking the wear of the seals and supporting rings.

Answers to some questions about series synchronous cylinder:

How does the one-way solenoid valve control the hydraulic cylinder circuit?
If your cylinder is single-acting, you can use a one-way solenoid valve, such as some lifting platform hydraulic cylinder, the support valve used is one-way (two-position tee), that is, the cylinder extends out by the oil pressure top, the cylinder retracted by its own weight.

There are four cylinders in the front top of the dump truck. When the second cylinder is lifted to half the height, it suddenly falls back more than 30 cm or so, and the cylinder continues to lift.
The problem is the cylinder, the second section of the different strength of the heart. When the oil supply resistance is small, the first out, when the power is not moving, the cylinder needs to be strong, because the second section needs to pop it out after a while when the pressure is large, the oil can not keep up, so it falls back, and the oil continues to keep up.

Back to list Recommended article

Leave a message if you have any questions.

Send
Email

Email:hsslrubbertech@gmail.com7x24 hours

Glad to receive your consultation!:

Service
Tel

+8613184968882
7x24hours service

Add
Wechat

Add Wechat