stern plate hydraulic cylinder Sold to Congo

This article mainly introduces:

Congo hydraulic cylinder,stern plate hydraulic cylinder manufacturer,stern plate hydraulic cylinder

(Congo stern plate hydraulic cylinder,produced by Hengyu Group）

stern plate hydraulic cylinder are widely used in Congo，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed stern plate hydraulic cylinder for customers from Congo.

Introduction to stern plate hydraulic cylinder:

When producing oil stern plate hydraulic cylinders, there are two processing processes, grinding and rolling, the latter is better than the former. Rolling machining is a kind of non-cutting machining, using the plastic deformation of the metal at room temperature, so that the micro roughness of the workpiece surface is flattened to achieve the purpose of changing the surface structure, mechanical characteristics, shape and size. Therefore, this method can achieve the two purposes of finishing and strengthening at the same time, which can not be done by grinding.

When the stern plate hydraulic cylinder is disassembled due to oil leakage and other faults, the position of the piston should be moved to any end position of the stern plate hydraulic cylinder by applying liquid pressure. Improper tapping and sudden drop should be avoided during disassembly.

When installing the stern plate hydraulic cylinder pipe, the pipe should be cleaned after installation, and should not pass through the stern plate hydraulic cylinder block, and the by-pass pipe must be installed in front of the oil port of the stern plate hydraulic cylinder block. This is important. Otherwise, the foreign body in the pipeline will enter the stern plate hydraulic cylinder, and once it enters, it is difficult to exclude it, but it becomes a foreign body transported to the stern plate hydraulic cylinder. Moreover, when cleaning, the removal method of foreign bodies entered in the installation pipeline operation should be considered. In addition, the corrosion in the pipe should be pickling and other procedures before the pipe installation, and the rust must be completely removed.

The stern plate hydraulic cylinder is not the same as the stern plate hydraulic cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the stern plate hydraulic cylinder can not be used as a high-power power component, but the stern plate hydraulic cylinder can be used as a relatively large power component, or the stern plate hydraulic cylinder system can be used.

Answers to some questions about stern plate hydraulic cylinder:

The cylinder is moving too fast. I want to slow it down. What can I do?
The hydraulic cylinder is the execution action, and the power source is the hydraulic system. The cylinder speed is too fast, indicating that the system flow is large, the hydraulic system has a hydraulic valve responsible for speed control function, method: 1, by adjusting the speed control valve to reduce the speed; 2, the speed control valve has been adjusted to the lowest, indicating that the hydraulic system design flow is too high, the need to re-configure the hydraulic system according to demand, or the cylinder diameter is changed.

What is the material of the cylinder support ring?
Generally, it is polytetrafluoroethylene doped with copper powder, or polyformaldehyde, and copper sleeves, there are also nylon, resin and so on.