electric forklift hydraulic cylinder Sold to Austria

This article mainly introduces:

Austria hydraulic cylinder,electric forklift hydraulic cylinder manufacturer,electric forklift hydraulic cylinder

(Austria electric forklift hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

electric forklift hydraulic cylinder are widely used in Austria，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed electric forklift hydraulic cylinder for customers from Austria.

Introduction to electric forklift hydraulic cylinder:

The "O" ring can be used as an auxiliary seal inside the electric forklift hydraulic cylinder, and the elastic force of the "O" ring makes the sealing slip ring close to the sealing surface, generating sealing pressure to achieve sealing. When the internal hydraulic pressure increases, the "O" ring will further deform and squeeze the slip ring, thereby increasing the sealing pressure and improving the sealing performance. The structure has the characteristics of low friction coefficient, good wear resistance, automatic compensation for wear and absorption of hard particles in the electric forklift hydraulic cylinder, and can be completely sealed.

After the electric forklift hydraulic cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.

The difference between the plunger electric forklift hydraulic cylinder and the piston electric forklift hydraulic cylinder is that the piston in the electric forklift hydraulic cylinder is replaced by a shaft plunger, which is used in hydraulic transmission requiring a long mechanical stroke, and can only input pressure oil from one direction, pressurize in a single direction, and form a thrust to push the plunger to move. The return trip of the plunger depends on the plunger itself to fall, and some rely on the spring to push back to the original position. Usually used plunger type electric forklift hydraulic cylinder, its inner hole does not need mechanical finishing, as long as the plunger round grinding can be assembled.

After chrome plating of the piston rod of the electric forklift hydraulic cylinder, the surface flatness is not fully treated: After chrome plating of the piston rod surface, the method of post-plating polishing should be changed to post-plating polishing. Although it is necessary to increase the thickness of the coating before grinding (generally increased by about 0.02 in the diameter direction), it can remove chrome plating defects well, and test the binding force of the coating. In addition, due to the micro-roughness of the grinding surface, the trough can store lubricating oil, which can improve the wear resistance and extend the service life.

Answers to some questions about electric forklift hydraulic cylinder:

There are four cylinders in the front top of the dump truck. When the second cylinder is lifted to half the height, it suddenly falls back more than 30 cm or so, and the cylinder continues to lift.
The problem is the cylinder, the second section of the different strength of the heart. When the oil supply resistance is small, the first out, when the power is not moving, the cylinder needs to be strong, because the second section needs to pop it out after a while when the pressure is large, the oil can not keep up, so it falls back, and the oil continues to keep up.

What are the standard cylinder models for hydraulic cylinders?
National standard GB/T2348-1993 specifies the hydraulic cylinder inner diameter series, you can check GB/T2348-1993 relevant regulations.