jacking hydraulic cylinder Sold to Ghana

This article mainly introduces:

Ghana hydraulic cylinder,jacking hydraulic cylinder manufacturer,jacking hydraulic cylinder

(Ghana jacking hydraulic cylinder,produced by Hebei Hengyu company）

jacking hydraulic cylinder are widely used in Ghana，because of high work efficiency，long service life，smooth movement.So our company has designed jacking hydraulic cylinder for customers from Ghana.

Introduction to jacking hydraulic cylinder:

We can not just consider the price and ignore the quality when we purchase the jacking hydraulic cylinders. Now some manufacturers produce unqualified products in order to reduce costs, the piston rod is not adjusted, the rod coating is not enough, the jacking hydraulic cylinder finish can not reach, the guide sleeve should use copper, but instead of ductile iron, although the cost is reduced, the quality of the jacking hydraulic cylinder is not required.

The jacking hydraulic cylinder is not the same as the jacking hydraulic cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the jacking hydraulic cylinder can not be used as a high-power power component, but the jacking hydraulic cylinder can be used as a relatively large power component, or the jacking hydraulic cylinder system can be used.

jacking hydraulic cylinder body inspection: The inner surface of the jacking hydraulic cylinder and the piston seal are the main factors causing the leakage in the jacking hydraulic cylinder, if the jacking hydraulic cylinder has a longitudinal tensile mark, even if the new piston seal is replaced, it can not effectively eliminate the fault, the inner surface of the jacking hydraulic cylinder mainly checks whether the dimensional tolerance and shape and position tolerance meet the technical requirements, there is no longitudinal tensile mark, and measures the depth of the longitudinal tensile mark, in order to take the corresponding solution.

In the case of serious wear on the inner surface of the jacking hydraulic cylinder, or when there is a deep longitudinal tensile mark, it should be mapped according to the physical object and re-produced by the professional manufacturer according to the jacking hydraulic cylinder manufacturing process for replacement. The jacking hydraulic cylinder can also be repaired with TS311 antiwear repair agent. TS311 anti-wear repair agent is mainly used for the repair of worn and slipped metal parts.

Answers to some questions about jacking hydraulic cylinder:

Why manual forklift oil cylinder can not lift up?
Manual hydraulic forklift truck often can not be pressed up, there are several reasons: for manual hydraulic truck: 1) There is no hydraulic oil 2) the purity of the oil is not enough 3) the adjusting bolt is too close or the adjusting screw is too tight, so that the valve is always open, 4) there is an air in the hydraulic cylinder. Method: 1) Refueling 2) Oil change 3) air discharge. For manual hydraulic stacker, also called manual lift car 1) Less than the amount of oil 2) impurities in the hydraulic oil, so that the check valve can not be closed. Method 1) Add enough hydraulic oil 2) Remove the cylinder, screw off the bottom plate, remove the impurities in the bottom plate.

What is the function of the Reza mounted master cylinder?
The role of the Resa-mounted master cylinder is to pump the concrete from the hopper to the delivery pipe and to provide sufficient concrete outlet pressure so that the concrete can reach the specified location.