pusher hydraulic cylinder Sold to Slovenia

This article mainly introduces:

Slovenia hydraulic cylinder,pusher hydraulic cylinder manufacturer,pusher hydraulic cylinder

(Slovenia pusher hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

pusher hydraulic cylinder are widely used in Slovenia，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed pusher hydraulic cylinder for customers from Slovenia.

Introduction to pusher hydraulic cylinder:

pusher hydraulic cylinder head explanation: low pressure castings, medium and low pressure with HT300 gray iron, medium and high pressure with 35, 45 steel. When the pusher hydraulic cylinder head itself is the guide sleeve of the piston rod, the pusher hydraulic cylinder head is best cast iron. At the same time, brass, bronze or other wear-resistant materials should be fused on the guide surface. If the guide sleeve is pressed into the pusher hydraulic cylinder head, the guide sleeve shall be wear-resistant cast iron, bronze or brass.

When the pusher hydraulic cylinder is repaired, its inner and outer diameter and roundness should be accurately measured. If the inner hole of the pusher hydraulic cylinder is badly worn, it can be repaired by grinding the mandrel or honing on the boring machine. If the piston is worn, it can be repaired by electroplating, and serious wear should be replaced.

Factors that should be considered when selecting the oil seal in the pusher hydraulic cylinder: some specific factors should be taken into account when selecting the oil seal in the pusher hydraulic cylinder, so as to have correct consideration and get accurate results, and then avoid wrong selection. The factors and aspects that should be taken into account are eight: pusher hydraulic cylinder diameter, piston rod diameter, piston rod and piston groove size, pusher hydraulic cylinder working pressure, pusher hydraulic cylinder movement speed, hydraulic system oil temperature and pusher hydraulic cylinder working environment.

In order to ensure the service life of the pusher hydraulic cylinder, the medium used must not be mixed with impurities and stolen goods, so as to avoid scratching the inner arm of the pusher hydraulic cylinder, causing damage to the seal and causing leakage in the pusher hydraulic cylinder. It is required that the filtration accuracy of the system is not less than 80μm, the oil pollution is strictly controlled, the hydraulic oil is kept clean, the performance of the hydraulic oil is regularly checked, and the necessary fine filtration or replacement of the new working hydraulic oil is carried out.

Answers to some questions about pusher hydraulic cylinder:

How to calculate hydraulic cylinder thrust?
Cylinder diameter = piston diameter =200MM Piston area =π (200/2) square =3140 square mm =31.4 square cm 25MPA=250KG/ square cm Maximum thrust = pressure * Piston area =250 *31.4 =7850KG=78500 Newtons This is the maximum thrust. The formula can be derived from the calculation formula.

How to distinguish cylinder rod head and cylinder bottom?
One end of the piston rod can be telescopic is the rod head, and the one behind is the bottom of the cylinder, which is the single rod cylinder.