reciprocating cylinder Sold to Canada

This article mainly introduces:

Canada hydraulic cylinder,reciprocating cylinder manufacturer,reciprocating cylinder

(Canada reciprocating cylinder,produced by Hengyu Group）

reciprocating cylinder are widely used in Canada，because of clever hydraulic energy conversion，excellent fatigue and impact resistance，simple structure and reliable operation.So our company has designed reciprocating cylinder for customers from Canada.

Introduction to reciprocating cylinder:

Do not enter foreign bodies when installing the reciprocating cylinder block. The place where the installation operation is carried out, the conditions are not good, and foreign bodies can be entered unconsciously. Therefore, the installation site must be cleaned up around, especially the place where the parts are placed must be cleaned, so that there is no dirt.

The reciprocating cylinder should be used correctly and maintained regularly. The reciprocating cylinder should be deflated before use, the buffer regulating valve should be adjusted to a reasonable position, the cleanliness of the oil should be checked regularly, the dust on the reciprocating cylinder should be cleaned regularly, and attention should be paid to waterproof and fireproof.

If air enters the hydraulic system, the reciprocating cylinder will not operate normally, mainly because there is a leak in the system. At this time, check the liquid level of the hydraulic tank, the seals and fittings on the oil suction side of the hydraulic pump, and whether the oil suction filter is too dirty. If so, the hydraulic oil should be replenished, seals and fittings should be treated, and the coarse filter element should be cleaned or replaced.

If the reciprocating cylinder slips or crawls, please check whether there is astringency inside the reciprocating cylinder, because the internal parts of the reciprocating cylinder are improperly assembled, the parts are deformed, worn or the shape and position tolerance is excessive, the action resistance is too large, so that the piston speed of the reciprocating cylinder changes with the different stroke position, and the slip or crawl occurs. Most of the reasons are due to poor assembly quality of parts, surface scars or sintered iron filings, so that the resistance increases, the speed decreases. For example, the piston is different from the piston rod or the piston rod is bent, the reciprocating cylinder or the piston rod is offset from the mounting position of the guide rail, and the sealing ring is too tight or too loose. The solution is to repair or adjust, replace damaged parts and remove iron filings.

Answers to some questions about reciprocating cylinder:

Why can't the hydraulic cylinder be pulled back after pushing to the limit?
May be long-term use to the limit position, resulting in serious wear caused! The solution is to add the stroke switch or disassemble and add gaskets before and after the piston.

What is the meaning of cylinder HSGK01-100/70E-4111-1320?
hsg Double acting single piston rod hydraulic cylinder and front end cover are connected by internal clamp key 01 Design serial number 100 cylinder inner diameter 70 piston rod outer diameter e Pressure class code 16mpa4111 Front flange, rod end external thread, both ends with buffer, oil port connection is internal thread 1320 stroke.