hydraulic cylinder for vehicles Sold to America

This article mainly introduces:

America hydraulic cylinder,hydraulic cylinder for vehicles manufacturer,hydraulic cylinder for vehicles

(America hydraulic cylinder for vehicles,produced by Hebei Hengyu company）

hydraulic cylinder for vehicles are widely used in America，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed hydraulic cylinder for vehicles for customers from America.

Introduction to hydraulic cylinder for vehicles:

When the hydraulic oil is not pumped into the hydraulic cylinder for vehicles, it is necessary to check whether the tubing, oil circuit, especially the hose joint has been blocked, and the relevant oil circuit from the hydraulic cylinder for vehicles to the pump should be checked in turn and blocked; Check whether the seal between the taper valve and the seat of the relief valve is good; Check whether the solenoid valve spring is damaged or whether the solenoid coil is burned out; Whether the oil circuit is switched is insensitive.

The hydraulic cylinder for vehicles should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the hydraulic cylinder for vehicles, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the hydraulic cylinder for vehicles wall due to the stiffness and the weight of the parts, causing scars.

How to determine the working pressure of the hydraulic cylinder for vehicles: The pressure depends on the load size (i.e., F) and the type of equipment. The limitations of assembly space, economic conditions and component availability of the actuator should also be considered. In the case of a certain load, it is necessary to increase the structural size of the actuator if the working pressure is low, for some equipment, the size may be limited, and it is not economical from the point of view of material consumption; On the contrary, if the pressure selection is too high, the material, sealing and manufacturing accuracy of the pump, hydraulic cylinder for vehicles, valve and other components are also required to be high, which will inevitably increase the cost of equipment. In general, for equipment with a fixed size that is not too limited, the pressure can be selected lower, and the walking machinery should be selected higher.

There are some honeycomb holes in the inner wall of the hydraulic cylinder for vehicles, piston or piston rod surface. How is this formed? When we repair the hydraulic cylinder for vehicles, we can see that there are some honeycomb holes on the inner wall of the hydraulic cylinder for vehicles, the piston or the piston rod surface, which are caused by cavitation. Therefore, the cavitation of the hydraulic cylinder for vehicles is targeted to prevent. Is very necessary.

Answers to some questions about hydraulic cylinder for vehicles:

What factors does the movement speed of the cylinder in the hydraulic system depend on?
The hydraulic system should be the piston movement in the cylinder, and the speed should also be the speed of the piston, according to the piston speed formula: v=4qm/pai*(D^2-d^2) where q is the flow rate of the input hydraulic cylinder, m is the volumetric efficiency of the hydraulic cylinder, D, d is the diameter of the piston and piston rod, because other factors are determined, the movement speed of the cylinder depends on the flow rate.

Hydraulic system schematic diagram, pipeline identification S and L, respectively corresponding nominal diameters? 16S is equivalent to DN12 high-pressure cylinder, and 15L means what?
16S refers to the high pressure series, outer diameter 16x2 steel pipe, the corresponding sleeve nut is M24X1.515L is the low pressure series, the outer diameter of 15x1.5 steel pipe, the corresponding sleeve nut is M22X1.5.