displacement sensor cylinder Sold to Croatia

This article mainly introduces:

Croatia hydraulic cylinder,displacement sensor cylinder manufacturer,displacement sensor cylinder

(Croatia displacement sensor cylinder,produced by Hengyu Hydraulic Co., Ltd）

displacement sensor cylinder are widely used in Croatia，because of smooth movement，powerful torque，clever hydraulic energy conversion.So our company has designed displacement sensor cylinder for customers from Croatia.

Introduction to displacement sensor cylinder:

The definition of the minimum starting pressure of the displacement sensor cylinder refers to the minimum working pressure of the displacement sensor cylinder in the no-load state, which is a comprehensive index reflecting the manufacturing and assembly accuracy of the displacement sensor cylinder parts and the size of the sealing friction.

displacement sensor cylinder to reasonable use of hydraulic oil: strict hydraulic oil selection off. Hydraulic oil is selected in strict accordance with oil standards. The selection of good quality hydraulic oil can effectively prevent bubbles in the working process of the hydraulic system. When choosing the oil, it should be selected according to the lowest temperature in different regions, and fill the hydraulic oil according to the dipstick standard, and at the same time, it should also keep the hydraulic system clean (when filling the hydraulic oil, it should prevent the water and other impurities into it), and often check the oil quality, oil level and oil color of the hydraulic oil. If blisters and bubbles are found in the hydraulic oil. When the oil becomes milky white, the source of the air in the oil should be carefully found and eliminated in time.

When the initial action of the displacement sensor cylinder is slow, please check the temperature of the hydraulic system, because in the case of low temperature, the viscosity of the hydraulic oil is large and the fluidity is poor, resulting in slow action of the displacement sensor cylinder. The improvement method is to replace the hydraulic oil with good viscosity temperature performance, and the oil temperature at low temperature can be increased by heater or heating by the machine itself, and the normal working oil temperature of the system should be maintained at about 40 ° C.

When the displacement sensor cylinder is repaired, its inner and outer diameter and roundness should be accurately measured. If the inner hole of the displacement sensor cylinder is badly worn, it can be repaired by grinding the mandrel or honing on the boring machine. If the piston is worn, it can be repaired by electroplating, and serious wear should be replaced.

Answers to some questions about displacement sensor cylinder:

Two cylinders in parallel, how to solve the synchronization problem?
The following methods can be used to achieve parallel cylinder synchronization: 1, rigid mechanical synchronization. 2. The throttle valve or speed regulating valve is used in the circuit to adjust the synchronization. 3, the two cylinders use independent quantitative pump oil supply to achieve synchronization. 4. Synchronous motor is used in the loop to realize cylinder synchronization. 5, using the position sensor to measure the stroke position and control the cylinder synchronization through the electrical system.

What are the main dimensions of the cylinder?
The main dimensions of the cylinder include: cylinder inner diameter, piston cylinder diameter, cylinder length, cylinder wall thickness, stroke, installation distance, etc.