rolling mill cylinder Sold to Canada

This article mainly introduces:

Canada hydraulic cylinder,rolling mill cylinder manufacturer,rolling mill cylinder

(Canada rolling mill cylinder,produced by Hebei Hengyu company）

rolling mill cylinder are widely used in Canada，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed rolling mill cylinder for customers from Canada.

Introduction to rolling mill cylinder:

The piston rod of the rolling mill cylinder has two kinds of solid rod and hollow rod, and one end of the hollow piston rod needs to be set aside for welding and heat treatment. The solid piston rod material is 35, 45 steel, and the hollow piston rod material is 35, 45 seamless steel pipe. After rough machining, the piston rod is conditioned to 229~285HB in India, and if necessary, the hardness is 45~55HRC after high-frequency quenching.

rolling mill cylinder use should try to avoid sealing belt into the rolling mill cylinder. As a simple sealing material, polytetrafluoroethylene plastic sealing tape is often used in installation and inspection, and if the winding method of the linear and ribbon-shaped sealing material is wrong, the sealing tape will be cut off and enter the rolling mill cylinder. The wire belt seal will not have any effect on the winding of the sliding part, but it will cause the check valve of the rolling mill cylinder to fail to operate or the buffer regulating valve can not be adjusted to the end. For the circuit, it may cause the action of the reversing valve, the relief valve and the reducing valve to fail.

The "O" ring can be used as an auxiliary seal inside the rolling mill cylinder, and the elastic force of the "O" ring makes the sealing slip ring close to the sealing surface, generating sealing pressure to achieve sealing. When the internal hydraulic pressure increases, the "O" ring will further deform and squeeze the slip ring, thereby increasing the sealing pressure and improving the sealing performance. The structure has the characteristics of low friction coefficient, good wear resistance, automatic compensation for wear and absorption of hard particles in the rolling mill cylinder, and can be completely sealed.

The scar on the sliding surface of the rolling mill cylinder piston will transfer with use. Before the piston is installed, there are scars on its sliding surface, which are installed intact and untreated, and these scars will in turn scratch the inner surface of the rolling mill cylinder wall. Therefore, before installation, these scars must be fully repaired.

Answers to some questions about rolling mill cylinder:

What's the use of three oil pipes on the cylinder?
The cylinder usually has an upper and lower oil chamber, one is connected to the upper oil chamber, one is connected to the lower oil chamber, sometimes a hydraulic lock will be added, that is, a hydraulic control check valve to prevent accidents when the oil pipe breaks, so the third pipe should be the control oil pipe of the hydraulic control check valve.

What are the main dimensions of the cylinder?
The main dimensions of the cylinder include: cylinder inner diameter, piston cylinder diameter, cylinder length, cylinder wall thickness, stroke, installation distance, etc.