stainless steel cylinder Sold to Switzerland

This article mainly introduces:

Switzerland hydraulic cylinder,stainless steel cylinder manufacturer,stainless steel cylinder

(Switzerland stainless steel cylinder,produced by Hengyu Hydraulic Co., Ltd）

stainless steel cylinder are widely used in Switzerland，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed stainless steel cylinder for customers from Switzerland.

Introduction to stainless steel cylinder:

The body of the stainless steel cylinder on the processing process requirements: the body of the stainless steel cylinder is an important and essential part of the stainless steel cylinder, because it has an irreplaceable role. The processing requirements for this part are very high, requiring that the surface roughness of the stainless steel cylinder after processing should reach 0.4-0.8um, and the coaxiality and wear resistance requirements are also very high.

In order to ensure the service life of the stainless steel cylinder, the hydraulic system must be set up effective filtration to prevent pollution, the cleanliness of the oil should meet the ISO4406 standard, and the quality of the filtration should also meet the corresponding standards in ISO. The grade requirements of the filter are performed according to the actual working conditions of the system, but the minimum requirements are not less than 19/15 in ISO4406, that is, 24μ (β10≥75) in ISO4572.

Regular maintenance of the stainless steel cylinder includes: regular tightening, stainless steel cylinder fastening screws and gland screws, stainless steel cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the stainless steel cylinder once a year. Clean regularly, the stainless steel cylinder is cleaned every other year, and the seals are replaced while cleaning.

When the stainless steel cylinder is in use, measures should be added to prevent the intrusion of pollutants. Effective measures should be taken to control the intrusion of pollutants, such as installing high-efficiency air filters in the tank breathing holes, new oil must be filtered, etc., but also must improve the anti-pollution ability of the stainless steel cylinder itself. In the seriously polluted environment, it is more important to pay attention to, such as the underground oil stainless steel cylinder should use fluorine rubber (FRM) and nitrile rubber (NBR) dust ring, and the ground mechanical stainless steel cylinder should use nitrile rubber dust ring; The filter device is added to the oil inlet of the stainless steel cylinder of the dump truck, construction machinery, work platform and other equipment, and in order to reduce the oil inlet resistance, the flow area should be increased as much as possible, which can effectively reduce the particle pollution from the system.

Answers to some questions about stainless steel cylinder:

Need to buy a hydraulic cylinder, now only know that the pressure needs to be between 20t and 50t. Two-way travel, how to determine the type of cylinder?
Important parameters of the cylinder: cylinder diameter, stroke, use pressure. First, the system pressure must be determined according to the precision of the operation of the application equipment, and the cylinder diameter can be determined by the force and system pressure. Then, according to how the equipment and the cylinder are installed and connected, determine the installation method of the cylinder and then determine the specific installation size, the size of the oil port, whether the buffer is needed and other details.

Can pneumatic cylinder be used as hydraulic cylinder?
The pneumatic cylinder can only be used for pressure below 1MPA, and if it is used for hydraulic, the pressure should be under 1MPA, which may not meet the strength requirements. And the seals should use fluorine rubber to avoid corrosion. But pneumatic cylinder used as hydraulic cylinder is not whimsical, in fact, there is such a use. The pneumatic system has a natural defect, that is, the speed is unstable, especially in the case of low speed. The hydraulic pressure is very stable, if you do not want to buy a set of hydraulic system, while the strength of the cylinder is not large, you can use compressed air to push the hydraulic oil, with hydraulic oil to drive the cylinder, The force is the same as compressed air, but very smooth.