High quality hydraulic equipment manufacturers!
TELL:+8613184968882

single rack cylinder Sold to America

Release time:2023-12-09 16:24:21 Hits: Current position: Home > News

This article mainly introduces:

America hydraulic cylinder,single rack cylinder manufacturer,single rack cylinder

America single rack cylinder

(America single rack cylinder,produced by Hengyu Hydraulic Cylinder Factory)

single rack cylinder are widely used in America,because of simple structure and reliable operation,excellent temperature resistance,no transmission clearance.So our company has designed single rack cylinder for customers from America.

Introduction to single rack cylinder:

The repair method of single rack cylinder wear: 1. Metal repair material is applied to the scratched surface; The first layer should be thin, uniform and fully covered with the scratched surface to ensure the best adhesion between the material and the metal surface, and then apply the material to the entire repair site and press repeatedly to ensure that the material is filled and reaches the required thickness, so that it is slightly higher than the surface of the guide rail; 2, the material at 24℃ to fully achieve the performance of 24 hours, in order to save time, can be through the tungsten halogen lamp to increase the temperature, the temperature rises 11℃, the curing time will be reduced by half, the best curing temperature 70℃; 3. After the material is cured, use a fine grinding stone or a scraper to repair and smooth the material higher than the surface of the guide rail, and the construction is completed.

When the single rack cylinder needs to be disassembled for maintenance due to leakage and other faults, the piston should be moved to the bottom position of the single rack cylinder, and hard beating and sudden drop are strictly prohibited during disassembly.

After the single rack cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.

The definition of the minimum starting pressure of the single rack cylinder refers to the minimum working pressure of the single rack cylinder in the no-load state, which is a comprehensive index reflecting the manufacturing and assembly accuracy of the single rack cylinder parts and the size of the sealing friction.

Answers to some questions about single rack cylinder:

How is the hydraulic cylinder selected in the mechanical design manual?
First of all, it is necessary to meet your work needs, and the second is to meet the structural space of the cylinder and accessories. Three to consider the other parameters of the cylinder.

How to deal with the surface degreasing process before spraying paint after cylinder assembly, and what degreasing agent is used?
Cylinder painting, generally using the following process (note: the cylinder is best painted, do not spray powder coating, because the powder coating curing temperature is high, will lead to sealing defects and oil leakage) : Pre-degreasing - degreasing - washing - washing - pickling - washing - washing - table adjustment - phosphating - washing - washing - drying - polishing - spray primer - spray paint degreasing agent generally use neutral or weak alkaline degreasing agent, phosphating liquid generally use zinc phosphating liquid.

Back to list Recommended article

Leave a message if you have any questions.

Send
Email

Email:hsslrubbertech@gmail.com7x24 hours

Glad to receive your consultation!:

Service
Tel

+8613184968882
7x24hours service

Add
Wechat

Add Wechat
TOP