retractable cylinder Sold to New Zealand

This article mainly introduces:

New Zealand hydraulic cylinder,retractable cylinder manufacturer,retractable cylinder

(New Zealand retractable cylinder,produced by Hebei Hengyu company）

retractable cylinder are widely used in New Zealand，because of high work efficiency，long service life，smooth movement.So our company has designed retractable cylinder for customers from New Zealand.

Introduction to retractable cylinder:

retractable cylinder use should try to avoid sealing belt into the retractable cylinder. As a simple sealing material, polytetrafluoroethylene plastic sealing tape is often used in installation and inspection, and if the winding method of the linear and ribbon-shaped sealing material is wrong, the sealing tape will be cut off and enter the retractable cylinder. The wire belt seal will not have any effect on the winding of the sliding part, but it will cause the check valve of the retractable cylinder to fail to operate or the buffer regulating valve can not be adjusted to the end. For the circuit, it may cause the action of the reversing valve, the relief valve and the reducing valve to fail.

If the retractable cylinder slips or crawls, please check whether there is astringency inside the retractable cylinder, because the internal parts of the retractable cylinder are improperly assembled, the parts are deformed, worn or the shape and position tolerance is excessive, the action resistance is too large, so that the piston speed of the retractable cylinder changes with the different stroke position, and the slip or crawl occurs. Most of the reasons are due to poor assembly quality of parts, surface scars or sintered iron filings, so that the resistance increases, the speed decreases. For example, the piston is different from the piston rod or the piston rod is bent, the retractable cylinder or the piston rod is offset from the mounting position of the guide rail, and the sealing ring is too tight or too loose. The solution is to repair or adjust, replace damaged parts and remove iron filings.

We can not just consider the price and ignore the quality when we purchase the retractable cylinders. Now some manufacturers produce unqualified products in order to reduce costs, the piston rod is not adjusted, the rod coating is not enough, the retractable cylinder finish can not reach, the guide sleeve should use copper, but instead of ductile iron, although the cost is reduced, the quality of the retractable cylinder is not required.

The body of the retractable cylinder on the processing process requirements: the body of the retractable cylinder is an important and essential part of the retractable cylinder, because it has an irreplaceable role. The processing requirements for this part are very high, requiring that the surface roughness of the retractable cylinder after processing should reach 0.4-0.8um, and the coaxiality and wear resistance requirements are also very high.

Answers to some questions about retractable cylinder:

What is the difference between hollow and solid oil cylinders?
Hollow solid cylinder, according to conventional understanding, refers to whether the piston rod is solid or hollow. General ordinary hydraulic cylinder, the piston rod is solid structure. Hollow hydraulic cylinder refers to a hollow piston rod structure of the hydraulic cylinder, see the attached figure. Piston rod hollow function: 1, the piston rod hollow, the middle can be threaded rod. For example, the clamping cylinder with a sawing machine, the piston rod center threading rod, part of the stroke through manual, part of the stroke hydraulic automatic walk. 2, the hollow hole of the piston rod can be used to direct the oil circuit to achieve special oil circuit. 3, the cylinder is relatively large, the piston rod is relatively large, and the stroke is longer, in this case, the piston rod is hollow to reduce the movement friction and lateral force.

How is the hydraulic cylinder selected in the mechanical design manual?
First of all, it is necessary to meet your work needs, and the second is to meet the structural space of the cylinder and accessories. Three to consider the other parameters of the cylinder.