discharge door cylinder Sold to Saudi Arabia

This article mainly introduces:

Saudi Arabia hydraulic cylinder,discharge door cylinder manufacturer,discharge door cylinder

(Saudi Arabia discharge door cylinder,produced by Hengyu Group）

discharge door cylinder are widely used in Saudi Arabia，because of excellent temperature resistance，no transmission clearance，powerful torque.So our company has designed discharge door cylinder for customers from Saudi Arabia.

Introduction to discharge door cylinder:

In order to ensure the service life of the discharge door cylinder, the medium used must not be mixed with impurities and stolen goods, so as to avoid scratching the inner arm of the discharge door cylinder, causing damage to the seal and causing leakage in the discharge door cylinder. It is required that the filtration accuracy of the system is not less than 80μm, the oil pollution is strictly controlled, the hydraulic oil is kept clean, the performance of the hydraulic oil is regularly checked, and the necessary fine filtration or replacement of the new working hydraulic oil is carried out.

When the discharge door cylinder is in use, once the seal and guide support ring are found to be defective, the seal with the same structural form and appropriate material should be replaced according to the structural form of the discharge door cylinder seal to be repaired, so as to minimize the thickness of the oil film between the seal and the sealing surface and reduce the leakage of the seal.

discharge door cylinder can not drive the load troubleshooting: oil pressure is too low. discharge door cylinder selection specifications are too small. Leakage in discharge door cylinder or associated hydraulic system element.

When the discharge door cylinder is installed, the piston and the discharge door cylinder head and other parts have large mass, large size and large inertia, even if there is a lifting equipment auxiliary installation, because the specified clearance is small, no matter how hard it will be put into, therefore, the end of the piston or the discharge door cylinder head boss is easy to cause scars when it hits the inner surface of the discharge door cylinder wall. The solution to this problem: for a large number of small products, the use of autocratic assembly oriented tools during installation; For heavy, thick and large large and medium-sized discharge door cylinders, only careful and careful operation can be avoided.

Answers to some questions about discharge door cylinder:

Why does the hydraulic cylinder go up to the top and then slowly go down?
Leakage in the cylinder or the hydraulic valve that controls the cylinder, can be replaced and removed. Or add a pressure retaining valve to the hydraulic system to ensure pressure.

The two cylinders of the bending machine are out of sync?
Check whether the sliding slide is worn, adjust its tightness, so that both sides are consistent, check whether the two cylinder tubing is connected, tighten the flow valve, pressure, let the cylinder air discharge.