Release time：2023-11-06 22:53:42 Hits： Current position: Home > News
This article mainly introduces:
Thailand trailer hydraulic cylinder,trailer hydraulic cylinder manufacturer
(Thailand trailer hydraulic cylinder,produced by Hebei Hengyu company）
trailer hydraulic cylinder are widely used in Thailand，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed trailer hydraulic cylinder for customers from Thailand.
When the trailer hydraulic cylinder is kept, do not pay attention to keeping the oil port open, which will produce the condition of accepting foreign bodies at all times, which is absolutely not allowed. Storage must be filled with anti-rust oil or working oil, and plug.
The trailer hydraulic cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the trailer hydraulic cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the trailer hydraulic cylinder wall due to the stiffness and the weight of the parts, causing scars.
Causes and countermeasures of oil trailer hydraulic cylinder leakage: Cast iron ring seal allows a certain degree of internal leakage. The impurities in the trailer hydraulic cylinder will lead to premature wear of the piston seal, replace the piston seal; If the trailer hydraulic cylinder is visibly scarred, the trailer hydraulic cylinder must be replaced. It can be pressurized at one end of the trailer hydraulic cylinder and opened at the other end of the oil port to observe whether there is obvious internal leakage at the end of the oil port. Most trailer hydraulic cylinder piston drift may not come from the trailer hydraulic cylinder, the above method to determine the trailer hydraulic cylinder without internal leakage is helpful to determine the problem of the hydraulic system related components.
The repair method of the trailer hydraulic cylinder: the repair of the trailer hydraulic cylinder must use brush plating. This is because this repair method can be carried out on site, and the repair effect is good. In this way, loading and transportation can be eliminated to shorten the repair time and improve work efficiency. In addition, the coating obtained by brush plating has good binding force and will not have obvious boundaries. Moreover, the repair surface has high hardness and good wear resistance.
How to remove the lifting cylinder from the forklift truck?
The lifting cylinder is generally fixed on the door frame, and there are screws under and above it, and it is OK to loosen the screws with a wrench on the top. However, we must pay attention to ensure safety and prevent damage to the cylinder or safety accidents.
100 tons press, the cylinder diameter is 250, how much pressure?
100 tons hydraulic press, if it is a single acting hydraulic cylinder, the required oil pressure is the nominal force divided by the cross-sectional area of the cylinder piston. One hundred tons of its pressure is 1000 kN (1000000N), the diameter of the cylinder is 250 mm, its area is the circular rate multiplied by the square of the radius, is 49062.5 square mm, and then the pressure divided by the area of the oil pressure is 20.38MPa. Therefore, a hydraulic pressure of 20.38 mpa is required for a 250 diameter cylinder to obtain 100 tons of pressure.
Add Wechat